1747-IN063C-EN-P, Universal Serial Bus (USB) to DH-485 ...

converter and the DH-485 device or interface first. See Connect DH-485 Devices to the Interface Converter’s RS-485 Port on page 5 or Connect DH-485 Devices to the Interface Converter’s RS-232 Port on page 6. IMPORTANT Do not connect more than one 1747-UIC interface converter to a single computer.

  Converter, 1747, 1747 uic

TCS3472 COLOR LIGHT-TO-DIGITAL CONVERTER with IR FILTER

The TCS3472 light-to-digital converter contains a 3 × 4 photodiode array, four analog-to-digital converters (ADC) that integrate the photodiode current, data registers, a state machine, and an I2C interface. The 3 ×4 photodiode array is composed of red-filtered, green-filtered, blue-filtered, and clear (unfiltered) photodiodes.

  Converter

a 8-Bit, 100 MSPS+ D/A Converter AD9708 - Analog Devices

TxDAC® D/A Converter FUNCTIONAL BLOCK DIAGRAM +1.20V REF REFLO REF IO FS ADJ 50pF COMP1 0.1mF CURRENT SOURCE ARRAY +5V AVDD SEGMENTED SWITCHES LATCHES DIGITAL DATA INPUTS (DB7–DB0) DVDD DCOM CLOCK SLEEP IOUTA IOUTB COMP2 ACOM 0.1mF +5V RSET CLOCK 0.1mF AD9708 FEATURES Member of Pin …

  Devices, Converter, Analog devices, Analog, A d converter

AN-1484Designing A SEPIC Converter - Texas Instruments

D max = V OUT + V D V IN (min) + V OUT + V D = 3.3 + 0.5 3.0 + 3.3 + 0.5 = 0.56 V IN Cin Cout L1 D1 Q1 L2 Cs Isen COMP FB AGND FA DR PG Rsn R1 Rf Rc Cc2 RL LM3478 Cc1 R2 V OUT V IN ICin (rms) = ' IL 12 Input Capacitor Selection www.ti.com 8 Input Capacitor Selection Similar to a boost converter, the SEPIC has an inductor at the input. Hence ...

  Converter, Texas, Texas instruments, Instruments, Spices, Sepic converter

Understanding Catalytic Converter Labeling

D-XXX-XX YYYYYY ZZZZ D-XXX-XX: This is the ARB approval number for the converter (known as the “EO number”). Every EO number will begin with “D”. The first three X’s wi ll be a 3 digit number corresponding to the manufacturer. The last two digits will be the specific approval number for the manufacturer.

  Converter, Catalytic, Catalytic converter

MCP2210 USB-to-SPI Protocol Converter with GPIO (Master …

USB-to-SPI Protocol Converter with GPIO (Master Mode) MCP2210 DS22288A-page 2 2011 Microchip Technology Inc. Block Diagram GPIO Control USB Protocol Controller USB XCVR VSS OSC State Clock USB Clock Reset 3.3V LDO 256-Byte EEPROM Configuration and Control Regs SPI (Master) Baud Generator Chip Select Control GP8-GP0 D+ D-V USB Vss OSC1 OSC2 …

  Converter

Microcontroller with 64K Bytes In-System Programmable Flash

A/D Converter PA7..0 PORT B (8) PB7..0. 4 2593O–AVR–02/12 ATmega644 The AVR core combines a rich instruction set with 32 general purpose working registers. All the 32 registers are directly connected to the Arithmetic Logic Unit (ALU), allowing two independent

  Converter, D converter

MC34063A - Inverting Regulator - Buck, Boost, Switching 1.5 A

MC34063A/D Inverting Regulator - Buck, Boost, Switching 1.5 A MC34063A, MC33063A, SC34063A, SC33063A, NCV33063A The MC34063A Series is a monolithic control circuit containing the primary functions required for DC−to−DC converters. These devices consist of an internal temperature compensated reference, comparator,

Low Voltage, 1.15 V to 5.5 V, 4-Channel, Bidirectional ...

Low Voltage, 1.15 V to 5.5 V, 4-Channel, Bidirectional Logic Level Translator Data Sheet ADG3304 Rev. E Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable.

  Devices, Analog devices, Analog