Search results with tag "Through hole"
INSTALLATION PANOPTIX LIVESCOPE INSTRUCTIONS …
static.garmin.com9 If you marked a pilot hole in step 8, use a 32 mm (1 . 1 / 4. in.) hole saw to drill a pass-through hole completely through the transom. 10Route the transducer cable to the sonar module: • If you are routing the cable using a pass-through hole, push it through the hole you drilled in step 9.
P-PTH 2-F v2 demo - IPC
www.ipctraining.orgMinimum Through Hole Land Shown below are the minimum acceptable conditions for a Class 3 Plated-Through Hole Solder Joint. All of the illustrations show the same solder connection from three
Handling, Packing, Shipping and Use of Moisture, Reflow ...
www.ipc.orgsolder, e.g., hand-soldering, hot bar attach of gull wing leads, and through hole by wave soldering. The heat absorbed by the package body from such operations is typically much lower than for bulk surface mount reflow or hot air rework and moisture precautionary measures are typically not needed.
SMT Board Assembly Process Guide - Intel
www.intel.comHere is a method for placing TC’s to measure SMT joint temperatures: Before the component is soldered to the board, drill a small hole through the pad of the joint to be measured Insert the thermocouple from the bottom of the board Hold the thermocouple tip flush with the top surface of the board
Through Hole Solder Joint Evaluation - IPC
www.ipctraining.org3 Through Hole Solder Joint Evaluation Training and Reference Guide Terminology Terminology Solder Destination Side: The side of a through hole …
THROUGH-HOLE LOW-PROFILE HEADER 8
suddendocs.samtec.comTHROUGH-HOLE LOW-PROFILE HEADER (2.00 mm) .0787" PITCH • TMM SERIES Gbps 8 Unless otherwise approved in writing by Samtec, all parts and components are designed and built according to Samtec’s specifications which are subject to change without notice. samtec.com?TMM Note: –D Some lengths, styles and options are non-standard, non-returnable.
THROUGH-HOLE .025 SQ POST HEADER
suddendocs.samtec.comRecommended hole size (1.02 mm ± 0.03 mm) .040" ± .001) –LC = Locking Clip (Styles –08 thru –13 & –22 only) (Requires 4 pin minimum) (Not available with T, –Q, –RA or–RE) –LA = –RA Option with –LL Option –“XXX” = Polarized Position RIGHT-ANGLE VERSIONS-RA LEAD STYLE SINGLE (–S) DOUBLE (–D) E TRIPLE (–T & –Q ...