Search results with tag "Ulpi"
USB3317C - Hi-Speed USB Transceiver with 1.8V-3.3V ULPI ...
ww1.microchip.comSMSC USB3317 REV C Revision 2.1 (06-02-10) DATASHEET PRODUCT FEATURES Datasheet USB3317 Hi-Speed USB Transceiver with 1.8V-3.3V ULPI Interface - 26MHz Reference Clock USB-IF “Hi-Speed” compliant to the Universal Serial Bus Specification Rev 2.0
USB3317C - Hi-Speed USB Transceiver with 1.8V-3.3V ULPI ...
ww1.microchip.comHi-Speed USB Transceiver with 1.8V-3.3V ULPI Interface - 26MHz Reference Clock SMSC USB3317 REV C 3 Revision 2.1 (06-02-10) PRODUCT PREVIEW General Description The USB3317 is a highly integrated Hi-Speed USB 2.0 Transceiver (PHY) that supports systems
Zynq UltraScale+ MPSoC Processing System v3 - Xilinx
www.xilinx.comULPI PS-GTR SMMU/CCI GFC USB 3.0 SGMII Low Power Domain Switch To ACP Low Power Full Power Battery Power 32-bit/64-bit 64-bit MS 128-bit MS LPD_PL HPC HPM GTY Quad GTH Quad Interlaken 100G Ethernet ACE DisplayPort Video and Audio Interface Low-latency Peripheral Port Low-latency Peripheral Port ACP 128 128 64 64 64
USB Solutions - Microchip Technology
ww1.microchip.commedia card and Smart Card formats. Our Hi-Speed USB 2.0 switches and ULPI-based transceiv-ers provide an ultra-small footprint and data multiplexing on a common connector with proven ESD protection, and our newest product line built around power delivery, enable 100W of power
Zynq-7000 SoC データシート 概要 - Xilinx
japan.xilinx.com• 外部 phy の接続用の 8 ビット ulpi インターフェイス • can 2.0b に完全に準拠した 2 つの can バス インター フェイス • can 2.0a、can 2.0b、iso 118981-1 規格に準拠 • 外部 phy インターフェイス • sd/sdio 2.0/mmc3.31 に準拠した 2 つのコントローラー
ZCU111 Evaluation Board - Xilinx
www.xilinx.comUSB 3.0 Transceiver and USB 2.0 ULPI PHY [B] SMSC USB3320-EZK, WURTH 692122030100 24 6 J100 SD Card Interface MOLEX 5025700893 28 7 U34, J83 UART0 (MIO 18-19) FTDI FT4232Hx-REEL, Hirose ZX62D-AB-5P8 29 8U46 SI5341B 10 Independent Output Any-Frequency Clock Generator Silicon Labs SI5341B-D07833-GM 40
STM32F405xx STM32F407xx - STMicroelectronics
www.st.comDMA, on-chip full-speed PHY and ULPI – 10/100 Ethernet MAC with dedicated DMA: supports IEEE 1588v2 hardware, MII/RMII LQFP64 (10 × 10 mm) LQFP100 (14 × 14 mm) LQFP144 (20 × 20 mm) UFBGA176 (10 × 10 mm) LQFP176 (24 × 24 …
USB hardware and PCB guidelines using STM32 MCUs ...
www.st.comULPI is required. D: USB 2.0 OTG HS controller with embedded on-chip HS PHYs The following table lists the STM32 devices supporting an USB and describes which USB peripheral is implemented in each of them. Table 3. USB implementation in STM32 devices Series / lines or references Supported USB(1) Size of dedicated packet buffer
LPC435x/3x/2x/1x Product Data Sheet
www.nxp.comfull-speed PHY and ULPI interface to external high-speed PHY. USB interface electrical test software included in ROM USB stack. One 550 UART with DMA support and full modem interface. Three 550 USARTs with DMA and synchronous mode support and a smart card interface conforming to ISO7816 specification. One USART with IrDA interface.
UTMI+ Low Pin Interface (ULPI) Specification
www.sparkfun.comRoute int pin to data(3) during 6-pin Serial Mode. Explain VBUS thresholds. Add T&MT diagram and updated text. Add new section to explain how PHY is aborted by Link. Various clarifications. 1.0rc2 January 13, 2004 Add block diagram. Tighten interface timing. Modify suspend protocol to more closely resemble UTMI.
Zynq-7000 SoC Data Sheet: Overview (DS190) - Xilinx
www.xilinx.com† 8-bit ULPI external PHY interface † Two full CAN 2.0B compliant CAN bus interfaces † CAN 2.0-A and CAN 2.0-B and ISO 118981-1 standard compliant † External PHY interface † Two SD/SDIO 2.0/MMC3.31 compliant controllers † Two full-duplex SPI ports with three peripheral chip selects † Two high-speed UARTs (up to 1 Mb/s)