18 WALL 14MOUNT SHOWER SEAT 17 5/8” 16”

Belvue, KS 66407(800) 669-9867 Fax: (800) Phone: Wall PreparationDrilling the HolesSeat LocationAttaching the SeatWALL MOUNT SHOWER SEATS ecuring & SealingWood backing is needed to support the SHOWER Seat. Install the backing as seen in the picture to the right. Use a 2 x 10 for the wood backing. Mount the backing so that its center is about 16 high off the floor. This will allow for the finished seat height to be 16 to 20 tall. If installing the Extended Corner Seat, be sure to extend the wood backing at least 24 from the the SHOWER wall is installed, position the corner seat at the desired height (normally between 17 and 19 above the base). Mark the wall through the pre-drilled holes under the seat for the hole step may require a second person to help. An easy test for how tight the bolts should be is to sit on the seat and listen for it to move (a squeaking sound). Tighten the bolts until the seat does not , having a bottle of rubbing alcohol and roll of paper towels ready will help clean up any silicone that may squeeze drill bits can be used when drilling through Onyx wall enlarging the clearance hole, be careful not to drill into the wood backing.

Belvue, KS 66407 • Phone: (800) 669-9867 • Fax: (800) 393-6699 • www.onyxcollection.com Wall Preparation

Tags:

  Walls, East, Shower, 18 wall 14mount shower seat 17 5 8 16, 14mount

Information