Transcription of Shower Drain Installation - Onyx Collection
{{id}} {{{paragraph}}}
Example: tourism industry
Shower Drain Installation - Onyx Collection
3412 Shower Drain InstallationThe picture above shows all the parts of your Shower Drain in the order they will be used during the WRENCH2" Drain PipeSub-Floor5" Diameter HoleDrain NutRubber & SlipWashersShower BaseDrain BodyShower Drain Disassembled:Applying Adhesive to FlangeInserting Drain Body from Top SideDrain Body Installed - View from Bottom Rubber Washer First, Then Slip WasherApply Onyx Adhesive to the under-side of the Drain Body flange all the way Drain Body in Shower Base before the Base is put in place on the floor. The Drain body is inserted from the top side and pressed firmly into place so that the Silicone Adhesive forms an even " Drain Pipe should be centered in a hole (approximately 5" diameter) in the flooring. The top of the Pipe should be no higher than, and no more than 1/8" lower than, the top surface of the floor on which the base will be Drain Nut, and then tighten the rest of the way (about 1/2 turn) with a Rubber Washer and Slip Washer around the Drain Body from the bottom side and thread the Drain Nut onto the Drain Body.
3 4 1 2 Shower Drain Installation The picture above shows all the parts of your shower drain in the order they will be used during the installation.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: