Analog to Digital Converters
ADC are used virtually everywhere where an analog signal has to be processed, stored, or transported in digital form. Some examples of ADC usage are digital volt meters, cell phone, thermocouples, and digital oscilloscope. Microcontrollers commonly use 8, 10, 12, or 16 bit ADCs, our micro controller uses an 8 or 10 bit ADC.
Tags:
Analog, Digital, Digital to analog
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
Digital to Analog Converter - gatech.edu
ume.gatech.eduR-2R Resistor Ladder DAC Each Bit controls a switch between ground and the inverting input of the op amp The switch is connected to ground if the corresponding bit = 0 2R Bit 3 Vout Bit 0 2R Vs 2R Bit 2 2R Bit 1 R +-RR R2R 4 Bit Converter V3 V2 V1 V0 R-2R DAC Example Ex. Convert 0001 to analog 2R Bit 3 Vout Bit 0 2R Vs 2R Bit 2 2R Bit 1 R +-RR ...
Electronics Exercise 3: Uni-Polar Stepper Motor Controller ...
ume.gatech.eduElectronics Exercise 3: Uni-Polar Stepper Motor Controller / Driver ... There are two types of stepper motors: bipolar and uni-polar. Current flows only in one direction through the coils of a uni-polar motor. ... Demonstrate a working circuit setup to your lab instructor in person. And submit your answers to the above questions by the due date.
Controller, Exercise, Drivers, Electronic, Working, Motor, Stepper, Stepper motor, Polar, Electronics exercise 3, Uni polar stepper, Uni polar stepper motor controller driver
Electro-Hydraulic Servo Valve Construction, Models and Use
ume.gatech.eduMOOG INC. CONTROLS DIVISION, EAST AURORA, NY 14052 TRANSFER INTRODUCTION FUNCTIONS FOR MOOG SERVOVALVES It is often convenient in servoanalysis
Functions, Valves, Transfer, Servo, Servovalves, Servo valves, Moog, Functions for moog servovalves
Introduction to Automation and Process Control
ume.gatech.eduIntroduction to Automation and Process Control An overview of automation, automation systems, and system engineering ... Data Transparency and Communications – ... complex networking have now been added to the PLC's
Related documents
3-Phase BLDC Motor Control with Sensorless Back EMF ... - NXP
www.nxp.comDual Analog-to-Digital Converter (ADC) modules—four inputs on each has the following feature set: • Eight total analog inputs • 12-bit range • Monotonic over entire range with no missing codes • First channel on each ADC can be swapped with the alternate ADC • Can perform two simultaneous analog-to-digital conversions
Converter, Analog, Digital, Dual, Dual analog to digital converter, To digital
14-Bit, 2.0 GSPS/2.6 GSPS, JESD204B, Dual Analog-to ...
www.analog.comThe AD9689is a dual, 14 -bit, 2.0 GSPS/2.6 GSPS analog-to-digital converter (ADC). The device has an on-chip buffer and a sample-and-hold circuit designed for low power, small size, and ease of use. This product is designed to support communications applications capable of direct sampling wide bandwidth analog signals of up to 5 GHz.
Converter, Analog, Digital, Dual, Digital to analog converter, Dual analog
MCP3202 - 2.7V Dual Channel 12-Bit A/D Converter with SPI ...
ww1.microchip.comAug 02, 2011 · analog-to-digital (A/D) converter with on-board sample and hold circuitry. The MCP3202 is programmable to provide a single pseudo-differential input pair or dual single-ended inputs. Differential Nonlinearity (DNL) is specified at ±1 LSB, and Integral Nonlinearity (INL) is offered in ±1 LSB (MCP3202-B) and ±2 LSB (MCP3202-C) versions.
7 Series FPGAs and Zynq-7000 SoC XADC Dual 12-Bit 1 MSPS ...
www.xilinx.com03/28/2011 1.1 Added “Dual 12-Bit MSPS Analog-to-Digital Converter” to document title. Modified first paragraph and added second paragraph in Chapter 1, Introduction and Quick Start . Added Table 1-1. Removed the Thermal Diode (DXP and DXN) section from Chapter 4.
Converter, Analog, Digital, Dual, Digital to analog converter
SECTION 6.1: DIGITAL-TO-ANALOG CONVERTER …
www.analog.comThere are two basic type of converters, digital-to-analog (DACs or D/As) and analog-to-digital (ADCs or A/Ds). Their purpose is fairly straightforward. In the case of DACs, they output an analog voltage that is a proportion of a reference voltage, the proportion based on the digital word applied. In the case of the ADC, a digital representation ...
TCS3472 COLOR LIGHT-TO-DIGITAL CONVERTER with IR …
cdn-shop.adafruit.comRed ADC Green ADC Blue ADC Clear Data Red Data Green Data Blue Data RGBC Control Blue Green Red Clear IR-Blocking Filter Detailed Description The TCS3472 light-to-digital converter contains a 3 × 4 photodiode array, four analog-to-digital converters (ADC) that integrate the photodiode current, data registers, a state machine, and an I2C ...
Converter, Analog, Digital, To digital, To digital converter
Build a Homebrew Radio Telescope - ARRL
www.arrl.orgto digital converter (ADC). The variable resis - tor in this voltage multiplier circuit is used to calibrate the CM to SkyPipe. The voltage from the multiplier is fed to a programmable interface controller (PIC) that is programmed as a 9-bit ADC to covert the analog voltage that is a function of received signal strength
Analog to Digital Conversion - mccdaq.com
www.mccdaq.comof the ADC, not with respect to the measured value at any particular instant. Successive-Approximation ADCs A successive-approximation converter, Figure 2.01, is composed of a digital-to-analog converter (DAC), a single comparator, and some control logic and registers. When the analog voltage to be measured
Converter, Analog, Digital, Digital to analog, Analog converter
Zynq UltraScale+ RFSoC RF Data Converter v2.4 Gen 1/2/3 ...
www.xilinx.comCharacteristics (DS926). Note that Dual and Quad refers to the tile configuration and not the number of converters. F e a t u r e s • Up to 16 14-bit RF-DACs • Gen 1/Gen 2: Four 12-bit Dual RF-ADC tiles, or four 12-bit Quad RF-ADC tiles • Gen 3: Two or four 14-bit Dual RF-ADC tiles, and/or two or four 14-bit Quad RF-ADC tiles