Transcription of CAD Standards User’s Guide - USDA
{{id}} {{{paragraph}}}
Example: tourism industry
CAD Standards User’s Guide - USDA
CAD Standards User's Guide May 2005. VERSION Introduction The following AutoCAD User's Guide was compiled by the Regional Office - Center for design and Interpretation (CDI) and represents a collaborated effort by the AutoCAD. Standards committee members (see Contributor/Reference page near back of document). These Standards are intended for Forest Service employees throughout the region, as well as architectural and engineering (A&E) contractors for the use in the preparation of computer aided design (CAD) construction and design drawings for the Forest Service. The purpose of this document is to establish Standards , which will result in the preparation of consistent and compatible AutoCAD files. It is intended to Guide users in the overall CAD system, operations, and to establish Standards and procedures that will avoid duplication of effort and maintain uniformity of work. Drawings that do not meet these requirements will be considered unacceptable. If special conditions make it impractical or impossible to conform to any of these requirements, the problem should be referred to the Project Manager and/or the Center for design and Interpretation.
Computer Aided Design (CAD) construction and design drawings for the Forest Service. The purpose of this document is to establish standards, which will result in the preparation of consistent and compatible AutoCAD files. It is intended to guide users in the overall CAD system, operations, and to establish standards and procedures that will
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: