Transcription of CHAPTER 16 STRUCTURAL DESIGN - iccsafe.org
{{id}} {{{paragraph}}}
CHAPTER 16 STRUCTURAL DESIGNSECTION provisions of this CHAPTER shall govern thestructural DESIGN of buildings, structures and portions thereofregulated by this 1602 DEFINITIONS AND following words and terms shall, forthe purposes of this CHAPTER , have the meanings shown STRESS method of proportion-ing STRUCTURAL members, such that elastically computed stressesproduced in the members by nominal loads do not exceed spec-ified allowable stresses (also called working stress DESIGN ).BALCONY, exterior floor projecting fromand supported by a structure without additional weight of materials of constructionincorporated into the building, including but not limited towalls, floors, roofs, ceilings, stairways, built-in partitions, fin-ishes, cladding and other similarly incorporated architecturaland STRUCTURAL items, and the weight of fixed service equipment,such as cranes, plumbing stacks and risers, electrical feeders,heating, ventilating and air-conditioning systems and firesprinkler exterior floor supported on at least two opposingsides by an adjacent structure, and/or posts, piers or other inde-pendent product of the nominal strengthand a
CHAPTER 16 STRUCTURAL DESIGN SECTION 1601 GENERAL 1601.1 Scope. The provisions of this chapter shall govern the structural design …
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Canadian Concrete Masonry Producers’, Canadian Concrete Masonry Producers’ Association Empirical Masonry Design, DESIGN FOR MASONRY, Technical Document Seismic Technical Guide, Seismic, Guide, Seismic design, GUIDELINES FOR THE SEISMIC, GUIDELINES FOR THE SEISMIC REHABILITATION OF BUILDINGS, Wall Selection Guide Section 1, Masonry, Brick Tie Design Section, For Masonry, Lintel Spec Guide, Design, Building Code Requirements for Masonry, Building Code Requirements for Masonry Structures, ITALIAN ANTI-SEISMIC LEGISLATION