Transcription of Chapter 6 The ISO System of Limits and Fits - …
{{id}} {{{paragraph}}}
Chapter 6 The ISO System of Limits and Fits - Tolerances and Deviations SUMMARY* The ISO System of Limits and Fits is a coordinated System of hole and shaft tolerances for engineering and manufacturing used for cutting tools, material stock, gages, etc. If held to these tolerances, cutting tools, material stock, and gages are generally available throughout the world. The hole basis fits have four preferred hole tolerances (H11, H9, H8, and H7); the shaft basis fits have four preferred shaft tolerances (h11, h9, h7, and h6) as shown in Table 6-1. The above shaft tolerances are now covered in the new ANSI standard. Select the basic size from Table 4-1 and one of the ten fits from Table 6-1 and read or cut and paste limit dimensions and clearances (interferences) from Tables 6-2 through 6-6 or CD.
Chapter 6 The ISO System of Limits and Fits - Tolerances and Deviations SUMMARY*
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
For Beginners: Essential Skills Every, CHAPTER, 1. General and Administrative Rules Chapter, 1. General and Administrative Rules Chapter 1. General and Administrative Rules, CONVEYANCING AND LAW OF PROPERTY, TO EMPLOYERS, 136 Chapter, Employers, DIGITAL RECORDING STANDARD, DIGITAL RECORDING STANDARD TABLE OF CONTENTS, CHAPTER Conceptual Framework of Health, Conceptual Framework of Health Determinants