CONTROL JOINTS FOR CONCRETE MASONRY …

Provided An i n f o r m aby: tion series from the national authority on CONCRETE MASONRY technology Cemex, Inc. CONTROL JOINTS FOR. CONCRETE MASONRY WALLS TEK 10-2C. EMPIRICAL METHOD Movement CONTROL (2010). INTRODUCTION. CONCRETE MASONRY is a popular construction material MASONRY veneers differ from the guidance presented be- because its inherent attributes satisfy the diverse needs of low. The reader is referred to TEK 10-4, Crack CONTROL both exterior and interior walls. While these attributes for CONCRETE Brick and Other CONCRETE MASONRY Veneers are the primary basis for CONCRETE MASONRY 's popularity, (ref. 3), for more detailed information. performance should not be taken for granted. Like all con- CONTROL JOINTS are one method used to relieve hori- struction systems, design decisions significantly influence zontal tensile stresses due to shrinkage of the CONCRETE field performance of the CONCRETE MASONRY wall system.

4 NCMA TEK 10-2C each side, or a horizontal bond beam could be used, as shown in Figure 2d. For best performance, the vertical reinforcement

Loading..

Tags:

  Control, Joint, Concrete, Control joints for concrete masonry, Masonry, Horizontal, Vertical

Information

Related search queries