Transcription of Cuti - Metra Online
{{id}} {{{paragraph}}}
Example: air traffic controller
Cuti - Metra Online
CAUTION! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running. TYTO-01 INSTALLATION COPYRIGHT 2017 Metra ELECTRONICS CORPORATION REV. 12/29/17 INSTTYTO-01 INTERFACE FEATURESINTERFACE COMPONENTSTOOLS REQUIRED Cutting tool Crimping tool Tape Connectors (example: butt-connectors, bell caps, etc.)TABLE OF CONTENTSC onnections to be made ..2-3 Installing the TYTO-01 ..3 Testing the TYTO-01 ..3 Toyota amplified interface 2001-up* Provides accessory power (12-volt 10-amp) Used in amplified systems High level speaker input USB updatable Retains balance and fade TYTO-01 interface 16-pin harness with stripped leads 14-pin to 20-pin harness with stripped leads*Visit for up-to-date vehicle specific inside front cover2
23˛˝˙ˆˇ˘ˇ ˘ˇ ˆ ˙ ˆ 3 From the 20-pin harness, to the aftermarket radio: • Connect the Yellow wire to the 12-volt battery/memory wire. • Connect the Black wire to the ground wire. • Connect the Red wire to the accessory/ignition wire. • Connect the Orange wire to the illumination wire. Note: If the aftermarket radio does not have an illumination wire, tape up and disregard the
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: