Transcription of Elastimold - tnb.ca
{{id}} {{{paragraph}}}
A41 Pre-molded terminationsCable terminationsElastimold cable terminations are available in a single-piece design. Terminators allow connection and transition from shielded, underground cable to bare overhead conductors and live-front equipment. Units are designed and rated per IEEE 48 for riser pole, padmount, indoor and outdoor applications. PCT1 and PCT2 terminators provide sufficient creep, strike and weather sealing for Class 1 outdoor service. PCT1 and PCT2 also include an integral cable jacket seal. Electrical ratings summaryThe following ratings summary is based on IEEE Standard 48 and applies to all the terminations on this page. Elastimold terminations are designed for use on three-phase systems, either 3-wire or 4-wire, and the single-phase laterals of these systems. Cable terminations DescriptionVoltage class (kV)Cat. terminator (class 1)15 PCT1-1X-4 Use table X9 N2, 3, 4, 525 PCT2-1X-4 Use table X9N2, 3, 4, 6 Housing only15 PCT1-4 N5 25 PCT2-4N6 Rod contact for PCT15/2500700X Use table X9N1, 3, 4 Two-hole spade for PCTAll01000X Use table X9N1 One-hole spade for PCT All01100X Use table X9N1 PCT positioning bracketAllPB-1N1, 7N1.
Elastimold® Cable Accessories w w w . t n b . c a A27 Cable Terminations Refer to the Wand Xtables on pages A39 to A41 for sizing to cable insulation diameter and conductor size.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
500 kV High Voltage, 60-500 kV High Voltage Underground Power, CA650003EN 600 A 15/25 kV, High, Voltage underground, Power, KV Class Loadbreak Elbow Connector, Underground, Elastimold, Voltage, 5 Hydroelectric Power, Development of 22-kV Distribution Systems and Switchgear, Development of 22 kV Distribution Systems and Switchgear, Voltage Backfeed on Distribution Lines, Eaton, Magnetic Field Measurement & Simulation of