Transcription of GEL COAT - Interplastic
{{id}} {{{paragraph}}}
Example: stock market
GEL COAT - Interplastic
DescriptionPossible CausesSolutionDelaminationGel coat ContaminationCheck lines and drain traps for wax/contaminants and dust on the coat Over CuredLaminate gel coat the same SeparationImproper Spray TechniqueSpray perpendicular to the Pressure Too HighReduce air or RunningApply 18 22 mils of gel TearingPump Pressure Too HighReduce for proper fan pattern with no Spray TechniqueUse proper technique to spray mold. Check for water ContaminationFreshly waxed mold, flange wax on mold surface. Empty line traps of water and oil and review your waxing Gel CoatMix gel coat 10 minutes maximum per day. Old material rotate your Pump PressureIncrease or decrease pump pressure for proper on MoldCheck for equipment on MoldDrain traps, review wax aged material. EquipmentClogged gun, Gel CoatMix gel coats 10 minutes maximum per Time Too LongIncrease catalyst and talk to Release WaxCheck for PatternThin Gel CoatEnsure you have 18 22 mils Mold SurfaceReview and refinish mold if coat Not CuredEnsure proper cure before Exotherm Too HotReduce catalyst and talk to of the LaminateEnsure proper cure before pulling Parts During PullingPolystyrene or Wax BuildupStrip the molds and Mold GlossBuff out the molds and Pulled Too SoonEnsure a proper
Descripción Causas Posibles Solución Delaminación Contaminación del gel coat Revise las líneas y trampas del drenaje estén libres de …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: