Transcription of General tolerances - 21food.cn
{{id}} {{{paragraph}}}
Example: barber
General tolerances - 21food.cn
BRITISH STANDARDBS EN22768-2:1993 ISO 2768-2:1989 General tolerances Part 2: Geometrical tolerances for features without individual tolerance indicationsThe European Standard EN 22768-2:1993 has the status of aBritish StandardUDC Copy: London South Bank University, London South Bank University, Wed Mar 15 03:46:41 GMT 2006, Uncontrolled Copy, (c) BSIBSEN22768-2:1993 This British Standard, having been prepared under the direction of the Machine, Engineers and Hand Tools Standards Policy Committee, was published under the authority of the Standards Board and comes into effect on15 July 1993 BSI 03-1999 The following BSI references relate to the work on this standard:Committee reference MTE/24 Draft for comment 87/78364 DCISBN 0 580 21934 8 Cooperating organizationsThe European Committee for Standardization (CEN), under whose supervision this European Standard was prepared, comprises the national standards organizations of the following countries:AustriaOesterreichisches NormungsinstitutBelgiumInstitut belge de normalisationDenmarkDansk StandardiseringsraadFinlandSuomen Standardisoimisliito, fran aise de normalisationGermanyDeutsches Institut f r Normung Organization for StandardizationIcelandTechnological Institute of IcelandIrelandNational Standards Authority of IrelandItalyEnte Nazionale Italiano di UnificazioneLuxembourgInspection du Travail et des
The use of general tolerances for size and geometry simplifies the task of ensuring that this prerequisite is met. 1 Scope This part of ISO 2768 is intended to simplify drawing indications and specifies general geometrical tolerances to control those features on the drawing which have no respective individual indication.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: