MT-016: Basic DAC Architectures III: Segmented DACs

latches are required to implement this ultra low glitch architecture. The basic current switching cell in the TxDAC family is made up of a differential PMOS transistor pair as shown in Figure 6. The differential pairs are driven with low-level logic to minimize switching transients and time skew. The DAC outputs are symmetrical differential

  Architecture, Basics, Adcs, Segmented, Glitch, Low glitch, Basic dac architectures iii, Segmented dacs

TCA9548A Low-Voltage 8-Channel I2C Switch with Reset ...

• Low RON switches • Allows voltage-level translation between 1.8-V, 2.5-V, 3.3-V, and 5-V buses • No glitch on power up • Supports hot insertion • Low standby current • Operating power-supply voltage range of 1.65 V to 5.5 V • 5-V Tolerant inputs • 0- to 400-kHz Clock frequency • Latch-up performance exceeds 100 mA Per JESD ...

  Glitch

NI 6229 Device Specifications - National Instruments

Power-off glitch 400 mV for 200 ms Output FIFO size 8,191 samples shared among channels used Data transfers PCI/PXI DMA (scatter-gather), interrupts, ... Output low current (IOL) PFI <0..15>/P1/P2 -— 16 mA Table 4. USB Devices Level Minimum Maximum Input …

  Glitch

PCA9535 PCA9535C 16-bit I2C-bus and SMBus, low power I/O ...

16-bit I2C-bus and SMBus, low power I/O port with interrupt No glitch on power-up Internal power-on reset 16 I/O pins which default to 16 inputs 0 Hz to 400 kHz clock frequency ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V MM per JESD22-A115, and 1000 V CDM per JESD22-C101

  Glitch

PCA9539; PCA9539R - NXP

16-bit I2C-bus and SMBus low power I/O port with interrupt and reset Polarity inversion register Active LOW interrupt output Active LOW reset input Low standby current Noise filter on SCL/SDA inputs No glitch on power-up Internal power-on reset 16 I/O pins which default to 16 inputs 0 Hz to 400 kHz clock frequency

  Glitch, Pca9539 pca9539r, Pca9539, Pca9539r

NI 6002 Device Specifications - National Instruments

SPECIFICATIONS NI USB-6002 Low-Cost DAQ USB Device The following specifications are typical at 25 °C, unless otherwise noted. For more information about the NI USB-6002 , refer to the NI USB-6001/6002/6003 User Guide

SGM58031 Ultra-Small, Low-Power, 16-Bit Analog-to-Digital ...

Ultra-Small, Low-Power, 16-Bit Analog-to-Digital Converter with Internal Reference . SG Micro Corp-micro.com. www.sg. MARCH 2020 – REV.A. 1. GENERAL DESCRIPTION . The SGM58031 is precision analogto-digital converter (ADC) with 16 bits of resolution. The SGM58031 is designed with precision, low power, and ease of implementation.

PCA9535E - I/O Expander for I 2 C Bus with Interrupt, Low ...

IOL Low−Level Output Current VOL = 0.4 V 6 mA CO Output Capacitance 2.1 5 pF INPUTS AD0, AD1, AD2 VIH High−Level Input Voltage 0.7 x VDD V VIL Low−Level Input Voltage 0.3 x VDD V IL Leakage Current VI = VDD or 0 V 1 A CI Input Capacitance 2.4 5 pF 6. The device is in standby mode after an I2C stop command. 7.