Transcription of GRX-TVI Control Interface
{{id}} {{{paragraph}}}
Example: bankruptcy
GRX-TVI Control Interface
Espa olFran aisPortugu sDeutschItalianoNederlands and Operation Instructions Please Read Before Installing Occupant CopyGRX-TVI Control InterfacePhase Control to 0-10 V- 100-277 V~ 50 / 60 HzDescription The GRX-TVI provides 0-10 V- Control and ballast/driver switching capabilities in one enclosure. The GRX-TVI gives a 100-277 V~ dimmer the ability to Control current sourcing 0-10 V- ballasts or LED drivers (loads) powered by 100-277 V~. The dimmer can be forward phase,reverse phase, or center phase (for a sample of approved dimmers, see the list on spec sheet P/N 369247).
to the terminals. The barrier must be in place when installation is complete. GRX-TVI Internal Terminal Block Label Defi nitions L2/H2 100-277 V~ Power input for GRX-TVI control (line voltage could be any voltage from 100-277 V~). Refer to Note at the end of page 1. N2 Neutral for GRX-TVI control DL2/DH2 Control feed from the control unit
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: