Transcription of HIGH DENSITY POLYETHYLENE (HDPE) PIPE
{{id}} {{{paragraph}}}
SECTION 1403 HIGH DENSITY POLYETHYLENE (HDPE) PIPE GENERAL Description of Work. The work under this section shall consist of furnishing and installing high DENSITY POLYETHYLENE (HDPE) pipe and fittings. The manufacturer shall be listed in the approved manufacturers list in Appendix A to these Standard Specifications. All materials must be in compliance with the plans and special specifications. Quality Assurance (A) HDPE pipe and fitting assemblies shall be manufactured from the product of one approved manufacturer.
The Inspector shall have free access to all joints and test joints for determining the suitability of the joining procedure. Where construction restrictions limit inspection of joints, the Engineer may have the person joining the pipe and/or fittings perform a test joint in the presence of the Engineer, or have the joint in question tested.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}