HYDROSTATIC PRESSURE TESTING - CORR TECH

HYDROSTATIC PRESSURE TESTING . Plastic pipe is not designed to provide structural strength Even though no leaks are found during the initial inspection, beyond sustaining internal pressures up to its designed however, it is recommended that the PRESSURE be maintained HYDROSTATIC PRESSURE rating and normal soil loads. Anchors, for a reasonable length of time. Checking the gauge several valves, and other connections must be independently times during this period will reveal any slow developing supported to prevent added shearing and bending stresses on leaks. the pipe. LOCATE ALL LEAKS. RISERS Even though a leak has been found and the pipe or joint has The above piping design rule applies also where pipe is been repaired, the low- PRESSURE test should be continued brought out of the ground. Above-ground valves or other until there is a reasonable certainty that no other leaks are connections must be supported independently.

HYDROSTATIC PRESSURE TESTING ... The piping system should gradually be brought up to the desired pressure rating using a pressure bypass valve to assure against over pressurization. The test pressure should ... designed maximum operating pressure, (b) the designed pressure rating of the pipe, (c) the designed pressure rating ...

Loading..

Tags:

  Operating, Testing, Pressure, Maximum, Piping, Hydrostatic, Hydrostatic pressure testing, Maximum operating pressure

Information

Related search queries