Transcription of INSTALLATION INSTRUCTIONS 2 ELECTRICAL GAUGES
{{id}} {{{paragraph}}}
Example: confidence
INSTALLATION INSTRUCTIONS 2 ELECTRICAL GAUGES
For use with:Sender Resistance (Ohms)FullEmptyMost GM vehicles 1965 to presentMost Ford & Chrysler vehicles3262 fuel level senderMost GM vehicles before 1965 Most Ford vehicles '87 to present07324001690103330158 Disconnect negative battery cable when wiring andreconnect to check IMountingThese GAUGES can be mounted in-dash or in Auto Meter mountingpanels (21 16" dia. hole for 2" GAUGES ) . Fasten with bracketssupplied as shown. (Hookup wire is required.) To assure properfunctioning of this instrument, please read INSTRUCTIONS thoroughlybefore :Some late model vehicles use electronic sensors in theirpressure and temperature senders for engine controlfunctions.
INSTALLATION INSTRUCTIONS 21/16" ELECTRICAL GAUGES ... terminal on back of gauge. For 100 psi fuel pressure connect (S) to sender terminal marked (S). CAUTION: Be careful not to touch ignition wire to the sender (S) terminal on back of gauge or the sender may be damaged. 5. Connect wire from center terminal GND (-) on back of gauge to good ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
INSTALLATION AND, Instructions, Fuel Gauge, Gauge, Installation Instructions, Instrument Kit Installation and Wiring Instructions, Analog / Digital Gauge System INSTALLATION, Fuel, Gauge Installation Instructions, Installation, INSTALLATION INSTRUCTIONS MECHANICAL gAUgES, Installation Instructions Fuel Gauge, Fuel gauge installation, Air/Fuel Ratio Monitor Installation Guide, Installation of Auto Meter Cobalt