Transcription of Instrument Kit Installation and Wiring Instructions
{{id}} {{{paragraph}}}
Page 1 Part #0 515 010 396 Rev. 11/95 THE Instructions FOR Installation AND ELECTRICAL Wiring FOR THE Instrument KIT FOLLOWS. USE IS RESTRICTED TO 12 VOLT NEGATIVE GROUND ELECTRICAL and Materials Needed For Installation :18 gauge stranded, insulated wireInsulated " spade terminals2 1/16" and 31/8" or 33/8" hole sawsDrill and drill bit setBolt cutter or similar toolHalf-round fileTape measure or rulerWrench or nut driver setPhillips screw driverUtility knifeGas-proof gasket sealantWeld-on Installation Kit (optional) P/N 226 901 Bolt-on Installation Kit (optional) P/N 226 451 Optional VDO Mounting Bracket (speedometer only)1. Select mounting locations for all gauges which provide goodvisibility for the driver.
THE INSTRUCTIONS FOR INSTALLATION AND ELECTRICAL WIRING FOR THE INSTRUMENT KIT FOLLOWS. ... Fuel Gauge (21/16" diameter) 1 4. Pressure Gauge (21/16" diameter) 1 ... Spin-Lok Mounting Clamp for gauges and speedometer 5 12. Instrument Kit Installation Instructions 1 13. Speedometer Installation Instructions 1 14. d" Œ 18 NPT to ‰" Œ 14 NPT ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Instrument Kit Installation and Wiring Instructions, Fuel Gauge, Gauge, Installation Instructions, Analog / Digital Gauge System INSTALLATION, Instructions, Fuel, Gauge Installation Instructions, Installation, INSTALLATION INSTRUCTIONS MECHANICAL gAUgES, Installation Instructions Fuel Gauge, Fuel gauge installation, Air/Fuel Ratio Monitor Installation Guide, Installation of Auto Meter Cobalt