Transcription of ISO 4759-1 E - 3ppars.com
{{id}} {{{paragraph}}}
Reference numberISO 4759-1 :2000(E) ISO 2000 INTERNATIONALSTANDARDISO4759-1 Second edition2000-11-15 Tolerances for fasteners Part 1:Bolts, screws, studs and nuts Productgrades A, B and CTol rances des l ments de fixation Partie 1: Vis, goujons et crous Grades A, B et CCopyright International Organization for Standardization Provided by IHS under license with ISO Not for ResaleNo reproduction or networking permitted without license from IHS--`,,```,,,,````-`-`,,`,,`,`,,`---ISO 4759-1 :2000(E)PDF disclaimerThis PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall notbe edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing.
The tolerances of form and position are specified and indicated in accordance with ISO 1101, ISO 8015 and ISO 2692. The tolerances specified in this part of ISO 4759 apply to fasteners prior to coating unless otherwise specified. See also ISO 4042.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}