Transcription of ISO 4759-1 E
{{id}} {{{paragraph}}}
Example: tourism industry
ISO 4759-1 E
Reference numberISO 4759-1 :2000(E) ISO 2000 INTERNATIONALSTANDARDISO4759-1 Second edition2000-11-15 Tolerances for fasteners Part 1:Bolts, screws, studs and nuts Productgrades A, B and CTol rances des l ments de fixation Partie 1: Vis, goujons et crous Grades A, B et CCopyright International Organization for Standardization Provided by IHS under license with ISO Not for ResaleNo reproduction or networking permitted without license from IHS--`,,```,,,,````-`-`,,`,,`,`,,`---ISO 4759-1 :2000(E)PDF disclaimerThis PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall notbe edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading thisfile, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in is a trademark of Adobe Systems of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameterswere optimized for printing.
International Standard ISO 4759-1 was prepared by Technical Committee ISO/TC 2, Fasteners, Subcommittee SC 7, Reference Standards for fasteners (mainly covering terminology, dimensioning, sizes and tolerancing). This second edition cancels and replaces the first edition (ISO 4759-1:1978), which has been technically revised.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: