Transcription of Lab: Basic Static Route Configuration
{{id}} {{{paragraph}}}
Example: dental hygienist
Lab: Basic Static Route Configuration
All contents are Copyright 1992 2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 1 of 20 Lab: Basic Static Route Configuration Topology Diagram Addressing Table Device Interface IP Address Subnet Mask Default Gateway R1 Fa0/0 N/A S0/0/0 N/A R2 Fa0/0 N/A S0/0/0 N/A S0/0/1 N/A R3 FA0/0 N/A S0/0/1 N/A PC1 NIC PC2 NIC PC3 NIC Learning Objectives Upon completion of this lab, you will be able to: Cable a network according to the Topology Diagram. Erase the startup Configuration and reload a router to the default state.
Task 2: Perform Basic Router Configuration. Note: If you have difficulty with any of the commands in this task, see Lab 1.5.1: Cabling a Network and Basic Router Configuration. Step 1: Use global configuration commands. On the routers, enter global configuration mode and configure the basic global configuration commands including: • hostname ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: