Transcription of Lab: Basic Static Route Configuration
{{id}} {{{paragraph}}}
All contents are Copyright 1992 2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 1 of 20 Lab: Basic Static Route Configuration Topology Diagram Addressing Table Device Interface IP Address Subnet Mask Default Gateway R1 Fa0/0 N/A S0/0/0 N/A R2 Fa0/0 N/A S0/0/0 N/A S0/0/1 N/A R3 FA0/0 N/A S0/0/1 N/A PC1 NIC PC2 NIC PC3 NIC Learning Objectives Upon completion of this lab, you will be able to: Cable a network according to the Topology Diagram. Erase the startup Configuration and reload a router to the default state. Perform Basic Configuration tasks on a router. CCNA Exploration Routing Protocols and Concepts: Static Routing Lab : Basic Static Route Configuration All contents are Copyright 1992 2007 Cisco Systems, Inc.
This document is Cisco Public Information. Page 4 of 20 Step 4: Add the exec-timeout command to the console and virtual terminal lines. To set the interval that the EXEC command interpreter waits until user input is detected, we can use the exec-timeout line configuration command. If no input is detected during the interval, the EXEC facility
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}