Transcription of Minimum Through-Hole Solder Joint …
{{id}} {{{paragraph}}}
Example: marketing
Minimum Through-Hole Solder Joint …
References: IPC-A-610E and IPC J-STD-001E IPC 2010, 3000 Lakeside Drive, Suite 309-S Bannockburn, IL 60015-1249 Tel. FAX: e-mail: rights reserved under both international and Pan-American copyright conventions. Any copying, scanning or other reproductions of these materials without the prior written consent of the copyright holder is strictly prohibited and constitutes infringement under the Copyright Law of the United fill of barrel = 75% Solder must fill at least 75%, or 3/4 the height of the hole . Wetting of component sidelead & barrel = 180 A properly wetted Solder fillet must circle at least 180 (or 1/2) of the way around the lead and barrel. The remaining 180 of the Solder connection may exhibit non-wetting, but it must fill the hole to the same height (75%) as the properly wetted of Solder sidelead, land & barrel = 270 A properly wetted fillet must extend at least 270 (or 3/4) of the way around the lead, land and barrel on the bot-tom or Solder side of the board.
References: IPC-A-610E and IPC J-STD-001E © IPC 2010, 3000 Lakeside Drive, Suite 309-S Bannockburn, IL 60015-1249 Tel. 847.615.7100 • FAX: 847.509.9798 www.ipctraining.org • e-mail: orderipc@ipc.org
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: