Transcription of MODEL SR830
{{id}} {{{paragraph}}}
MODEL SR830 . DSP Lock-In Amplifier 1290-D Reamwood Avenue Sunnyvale, California 94089. Phone: (408) 744-9040 Fax: (408) 744-9049. email: Copyright 1993, 2011 by SRS, Inc. All Rights Reserved. Revision (10/2011). TABLE OF CONTENTS. GENERAL INFORMATION REAR PANEL. Safety and Preparation for Use 1-3 Power Entry Module 4-27. Specifications 1-5 IEEE-488 Connector 4-27. Abridged Command List 1-7 RS232 Connector 4-27. Aux Inputs (A/D Inputs) 4-27. GETTING STARTED Aux Outputs (D/A Outputs) 4-27. X and Y Outputs 4-27. Your First Measurements 2-1. Signal Monitor Output 4-28. The Basic Lock-in 2-3. Trigger Input 4-28. X, Y, R and q 2-7. TTL Sync Output 4-28. Outputs, Offsets and Expands 2-9. Preamp Connector 4-28. Storing and Recalling Setups 2-13.
the fuse holder cover door and rotate the fuse-pull lever to remove the fuse. Remove the small printed circuit board and select the operating voltage by orienting the printed circuit board so that the desired voltage is visible when pushed firmly into its slot. Rotate the fuse-pull lever back into its normal position and insert the correct fuse ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}