Transcription of MPFI FUEL INJECTION SYSTEM
{{id}} {{{paragraph}}}
Example: barber
MPFI FUEL INJECTION SYSTEM
1 MPFI fuel INJECTION SYSTEM QUICK START MANUAL 199R11956 NOTE: These instructions must be read and fully understood before beginning installation. If this manual is not fully understood, installation should not be attempted. Failure to follow these instructions, including the pictures may result in subsequent SYSTEM failure. 2 TABLE OF CONTENTS: INTRODUCTION .. 3 WARNINGS, NOTES, AND NOTICES .. 3 ADDITIONAL ITEMS REQUIRED FOR INSTALLATION .. 3 TOOLS REQUIRED FOR INSTALLATION .. 4 REMOVAL OF EXISTING COMPONENTS .. 4 terminator X MPFI SYSTEM 4 fuel Pump, fuel Line, and Filter 4 Oxygen Sensor Installation .. 4 Oxygen Sensor Mounting Procedure .. 5 ECU Mounting .. 5 WIRING .. 5 Important Wiring Do s and Don ts .. 5 WIRING HARNESS INSTALLATION .. 6 Main Power/Battery Connection .. 6 PRIMARY HARNESS INSTALLATION AND SENSOR CONNECTIONS .. 6 ECU Connectors .. 7 Harness Routing .. 7 Sensor Connections & Outputs.
A complete high pressure EFI fuel system must be installed for the TERMINATOR X™. The pump should be capable of supplying a minimum of 255 liters/hour or 400 lb./hr. of fuel at 43 psi. If using an in-line fuel pump, there should be a coarse pre-filter before the pump. All systems should contain a 10 micron post filter after the fuel pump.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: