Liverpool Wards A3Lv2 2-DesignEdit-220621

C r e k Prospect G E O R G E S R I V E R D e a d m a n s C o m pl e t e C r ek C r e e k H a r is C r e k C r e k B u n bu ry Cu ra n G E O R G E S Wa tle Grove Dete ...

RS-1 District Schedule - Vancouver

multiple conversion dwellings in conjunction with retention of character houses. Emphasis is ... of all accessory buildings is not greater than 30% of the minimum rear yard prescribed in this Schedule, or 48 m 2, whichever is the greater, except that: ... Two-Family Dwelling, on lots less than 511 m 2 in area. 2.2.I [Institutional] ...

  House, Greater, Dwelling, Lots, Lot no

RS-5 District Schedule - Vancouver

5 District in the form of one-family dwellings, secondary suites, and laneway houses, by encouraging new development that is compatible with the form and design of existing ... family dwellings with secondary suites on larger lots and with lock-off units on smaller lots, and infill and multiple conversion dwellings in conjunction with retention ...

  House, Lots

SEATTLE'S SINGLE-FAMILY RESIDENTIAL ZONES

ing units in small-scale structures on lots in urban villages. RSL allows for a broader range of housing types through new development and conversion of existing single-family houses into multiple dwelling units. Lots can have attached or stacked principal dwelling units, which is not allowed in SF 5000, SF 7200, or SF 9600 zones. Housing Type

  Family, House, Single, Residential, Seattle, Dwelling, Lots, Lot no, Seattle s single family residential

SEATTLE'S LOWRISE MULTIFAMILY ZONES

Accessory Dwelling Units (ADUs) are allowed with single-family dwelling units, rowhouses and townhouses in LR zones, subject to specific development stan-dards per 23.45.545.I. ADUs do not count towards the density limit. See SMC 23.84A.032 for complete housing type definitions. Multifamily housing that is not cottage housing, rowhouses, or town-

  Seattle, Dwelling, Multifamily, Lowrise multifamily, Lowrise

Side and rear setbacks for residential development

provisions for houses and ancillary outbuildings. Rear setbacks are based on the area of the lot and ensure that a development is provided with a reasonably sized back yard for the size of the lot, whilst protecting the amenity of adjoining houses. Table 2: Minimum rear setback requirements for dwelling houses by lot area . Building height up to:

  House, Dwelling, Dwelling houses

Setbacks from roads and articulation zones

requirements for dwelling setbacks from roads, and how a corner lot is identified. This specifically relates to whether the bend in the road in less or greater than 135 degrees. Figure 4 indicates dwelling front setbacks from a primary road and indicates when a bend in a road becomes a corner lot. January 2015 Page 4 of 5

  Greater, Dwelling

Road Width

to abutting lots” or serving as a connection between such roads and collector roads. Some regulations do not include definitions for the road types. For consistency, researchers coded “typical subdivision” as the street intended to serve 10-30 houses or 100-300 vehicle trips per day or closest equivalent category.

  House, Lots

State Planning Policy 7.3 Residential Design Codes Volume 1

houses as per clause 2.2.2. 2. The R-Codes do not require planning approval for a single house on a lot greater than 260m2 or a lot subject to an approved local development plan or local structure plan; although, a scheme may require planning approval for a single house irrespective of the requirements of the R-Codes as per clause 2.3. 3.

  House, Greater