Transcription of POWER TRAIN - Rotaryheads
{{id}} {{{paragraph}}}
POWER TRAIN . PROPELLER SHAFT (w). PROPELLER SHAFT LOCATION INDEX. 1 Propeller shaft PROPELLER SHAFT REMOVAL/INSTALLATION. For Carbon-Fiber Propeller Shaft CAUTION: The carbon-fiber-reinforced propeller shaft could be chipped or cracked if dropped. To prevent any damage, handle the shaft with careful attention when removing/installing. Replace the propeller shaft if it is dropped. (w) RX-8 POWER TRAIN Page 1. 1. Remove the front tunnel member. 2. Remove the rear tunnel member. 3. Remove the exhaust pipe and the silencer. 4. Remove the heat insulator. 5. Protect the propeller shaft with rubber padding or similar protective cover to prevent damage. CAUTION: Remove the rubber padding or similar protective cover after propeller shaft installation is complete.
•If it exceeds the maximum specification, replace the propeller shaft. Maximum runout o 0.4 mm {0.016 in} 2. Inspect the play and rotation of the joint by turning the universal joint in the directions shown by the
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}