Transcription of (PROJECT STANDARDS AND SPECIFICATIONS)
{{id}} {{{paragraph}}}
Example: tourism industry
(PROJECT STANDARDS AND SPECIFICATIONS)
Page : 1 of 21. KLM Technology Group Rev: 01. Project Engineering April 2012. Standard KLM Technology Group #03-12 Block Aronia, SPECIFICATIONS FOR PUMP INSPECTION. Jalan Sri Perkasa 2. Taman Tampoi Utama 81200 Johor Bahru (PROJECT STANDARDS AND SPECIFICATIONS). Malaysia TABLE OF CONTENT. SCOPE 2. REFERENCES 2. DEFINITIONS AND TERMINOLOGY 2. GENERAL 2. INTRODUCTION 2. PREDICTIVE MAINTENANCE SCHEDULE FOR CENTRIFUGAL PUMPS 3. PREVENTIVE MAINTENANCE INSPECTION SCHEDULE FOR. CENTRIFUGAL PUMPS 3. Horizontal Centrifugal Pumps (Both ends supported) 3. Horizontal Centrifugal Pumps (Overhanging Type) 5. Submersible Pumps (Wet Motor Type & Dry Motor Type) 6. Vertical Centrifugal Pumps 7. Partwise Inspection during complete Overhaul of Centrifugal Pumps 8.
SPECIFICATIONS FOR PUMP INSPECTION SPECIFICATIONS) Page 4 of 21 Rev: 01 2. After 4000 running hours or 1 year whichever earlier i. Repeat all checks per No: 1. ii. Flushing of bearing with lube oil and refilling of oil to required level, whether carried out or not iii. Flushing of cooling water lines and strainers, whether carried out or not
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: