UMC Ultraminiature Connectors - Bel - Power

Part No. Teflon Coaxial Cable O.D. Cable Length Connector A Height Connector B 415-0089-150 0.81 mm 150 mm UMC LP PLUG 2.0 mm SMA STR. PLUG 415-0089-250 0.81 mm 250 mm UMC LP PLUG 2.0 mm SMA STR. PLUG Low Profile UMC Right Angle Cable Plug to SMA Straight Jack Part No. Teflon Coaxial Cable O.D. Cable Length Connector A Height …

  Connectors, Ultraminiature, Umc ultraminiature connectors

Connectivity and Structured Cabling

(M) = Male Plug (F) = Female Socket RF Connectors & Adapters 5 Part No . Compatible Cable Crimper Stripper 28-91007 (CPMC782) Belden 1505A, 24-9959P 24-7732P

The 0RQB-30Y05L is an isolated DC/DC converter providing ...

The 0RQB-30Y05L is an isolated DC/DC converter providing 30 W of output power from a wide input range (24 V, 48 V, 72 V, 96 V, 110 V typical). Standard features include remote on/off, input under-voltage

  Ranges, Input, Voltage, Wide, Wide input range

RoHS compliant Ultra-wide 3.5 to 16 volt input range Input ...

Ultra-wide input voltage range allows operation from battery power as well as system power. The output is electrically isolated, thereby allowing the output to be configured as a positive or negative output voltage. Fully-isolated and filtered outputs permit usage in sensitive and low noise circuits.

  Ranges, Input, Voltage, Wide, Wide input voltage range, Input range input

The Bel Power Solutions produces ... - Bel - Power | Protect

E, F OVP-24G DUAL OUTPUT AA, B, BB, CC OVP-12G protects both outputs E OVP-24G protects both outputs TRIPLE OUTPUT AA, BAA, D CBB, 131 DBB, DCC OVP-12G protects both 12 V through 15 V outputs PEAK CURRENT MODELS N, BAA, CBB 131 OVP-12G protects any output not provided with built-in OVP

Surface Mount PTC - Bel Fuse

6. If potting is mandated, avoid rigid potting compounds as they will encase the PTC and prevent it from volumetrically expanding to properly respond to a trip event. 7. MSL: 2a (According to IPC J-Std-020). P S W Nominal Nominal Nominal mm Inch mm Inch mm Inch 2.00 0.079 1.00 0.039 1.90 0.075 All dimensions in mm. Part Number

  Compound, Potting, Potting compounds

°C

Solder Reflow Due to “lead free / RoHS 2 ” construction of these PTC devices , the required Temperature and Dwell Time in the “ Soldering ” zone of the reflow profile are greater than those used for non-RoHS devices. 1. Recommended reflow methods; IR, vapor phase oven, hot air oven. 2. Not Recommended For Wave Solder / Direct Immersion. 3.

  Free, Deal, Solder, Lead free

AEC-Q Compliant - Bel Fuse

n 0zcg0300ff2b 3.00 5.00 6 100 1.0 8.0 4.000 0.012 0.040 y y IH Hold Current- The maximum current at which the device will not trip in still air at 23°C. IT Trip current- The minimum current at which the device will trip in still air at 23°C.

Wire and Cable - UL Code Authorities

When these assemblies use Recognized cable and are sent to a building site separately, instead of being supplied with the equipment, these cable assemblies may be identified as Listed Computer Interconnection Cable Assemblies (DVPJ). Similarly, for communication equipment, Listed Communication Cable Assemblies (DUNH) may be used. AWM

  Wire, Cable, Assemblies, Wire and cable, Cable assemblies

Marking Guide Wire and Cable - escventura.com

communication equipment, Listed Communication Cable Assemblies (DUNH) may be used. AWM ratings and conditions of acceptability are shown on a tag affixed to the reel or carton. Some ratings may appear on the surface of the wire or cable. The UL label is required for Listed, Classified, and Verified wire and cable products and can be

  Guide, Wire, Marking, Cable, Assemblies, Wire and cable, Cable assemblies, Marking guide wire and cable

BUCCANEER FOR POWER 400 Series Buccaneer

Cable range from 3 to 7mm Overall length (flex + flex in-line) 80mm Gold plated contacts Diameter over coupling ring 19.1mm. Pre-wired, overmoulded cable assemblies Flex, Flex In-Line, Front Panel, Rear Panel and PCB mounting body styles. Plug and Socket versions in all body styles Flame Retardant moulding material - Polyamide UL94-V0

  Cable, Assemblies, Cable assemblies

The new standard IEC 61439 Low voltage switchgear and ...

Assemblies which may generally be considered has been collected with specific aspects such as, for example, heating, dielectric properties, etc. ... wide cable compartment can accommodate a staged busbar of max. 400 A and a terminal or may serve as a …

  Cable, Assemblies

POWER CABLE INSTALLATION GUIDE - Anixter

c) From cable reel to cable tray, the cable is fed from the top of the reel to main-tain required curvature. Sheaves, or a shoe, may be used to guide the cable into the tray. Figure F-3 Cable Feed into Cable Tray d) Cable sheaves or a shoe may be used to guide cable into the desired direction, maintain minimum bend radius, and reduce friction.

  Cable, Anixter

Cables and Connectors Class Document - USB

As such, it defines how USB 3.1 legacy connectors and cables assemblies are to be tested and how manufacturers will interact with the voluntary compliance requirements. This document does not cover USB 3.1 Gen 2 electrical, USB Type-C™ connectors, USB Type-C to Legacy cable assemblies, or USB Type-C to Legacy adapter assemblies. 1.3.

  Document, Class, Connectors, Cable, Assemblies, Cables and connectors class document, Cable assemblies

IPC-A-610G: Acceptability of Electronic Assemblies table ...

Assemblies Developed by the IPC-A-610 Task Group (7-31b) of the Acceptability Subcommittee (7-31) of the Product Assurance Committee (7-30) of IPC Usersof this publicationare encouragedto participatein the developmentof futurerevisions. Contact: IPC Supersedes: IPC-A-610F WAM1 - February 2016 IPC-A-610F - July 2014 IPC-A-610E - April 2010

  Assemblies