Transcription of Solidworks Tutorial: Beginner Flow Simulation …
{{id}} {{{paragraph}}}
Example: tourism industry
Solidworks Tutorial: Beginner Flow Simulation …
Solidworks Tutorial: Beginner Flow Simulation Tutorial Introduction Solidworks has built in computational flow dynamics capabilities that are very useful for determining the effect of fluid flow on a solid model. However, these functions can be complicated and confusing to use. This tutorial is intended to give basic instruction on how to setup and run a basic flow analysis. This is not intended to be a comprehensive flow Simulation instruction, but it is a good place to start. Tutorial 1) Open Solidworks 2) Open Part - Pressure Vessel 3) Make assembly from part Solidworks Tutorial: Beginner Flow Simulation Tutorial 4) Solidworks will require a closed system to be analyzed. In this step we will close the geometry on the system by adding lids to the pipes. a) Click the arrow below Insert Components and select New Part b) Using Sketch and Features tools, create a lid for each pipe.
Solidworks Tutorial: Beginner Flow Simulation Tutorial 5) Open FloXpress Note: FloXpress will not work if the Flow Simulation add-in is currently installed.If it is
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Beginner’s Guide to SolidWorks 2014 - Level, Gears SolidWorks Samples 6-13, Solidworks, Getting Started with NI SoftMotion for SolidWorks, I Know Everything About, SolidWorks SolidWorks, SolidWorks Simulation, SOLIDWORKS SOLIDWORKS Simulation, How to create, How to create compression spring, SOLIDWORKS : Lesson 1 - Basics and Modeling