Transcription of Speed Bumps - Asphalt General
{{id}} {{{paragraph}}}
Example: air traffic controller
Speed Bumps - Asphalt General
Speed Bumps 1. Lay out and mark area for placement of Speed Bumps . 2. Clean area of all dirt and debris. 3. Notch existing Asphalt surface to alleviate Speed bump displacement. 4. Tack coat area of installation using liquid Asphalt . 5. Install hot mix surface Asphalt to a maximum height of 3-1/2 at the apex and a width of 18 . 6. Apply a seal of liquid Asphalt to the adjoining edge of the installation to help prevent moisture penetration. 7. Apply heavy-duty reflective traffic paint sufficient to identify the Speed bump.
Speed Bumps 1. Lay out and mark area for placement of speed bumps. 2. Clean area of all dirt and debris. 3. Notch existing asphalt surface to
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Mix Asphalt (WMA) Guide Specification, Mix asphalt, Mix Asphalt (WMA) Guide Specification for Highway Construction, Asphalt, SECTION 39 ASPHALT CONCRETE Issued 06-05, HOT -MIX, HOT -MIX ASPHALT IN PAVEMENTS, MIX COLD-LAID ASPHALT CONCRETE, MIX COLD-LAID ASPHALT CONCRETE PAVEMENT, Pavement Surface Evaluation and Rating Asphalt, Comparison of Marshall and, Mix Design for Asphalt Mixes, CONSTRUCTION SPECIFICATION FOR HOT MIX