Transcription of Steel decking diaphragm design
{{id}} {{{paragraph}}}
diaphragm the easiest way to specify metal decking : diaphragm design New Millennium has provided the following tables based on the Steel Deck Institute diaphragm design Manual, Third Edition, to assist designers. Refer to the next page for a design example illustrating the use of the tables. The tables include values for roof decks with fastener type combinations of welds and screws for applications without fill (bare deck) and with concrete fills. Visit for tools to create diaphragm shear strength tables for roof decks using power-actuated fasteners and also for creating tables for all design conditions using floor decks. The values shown in the tables are nominal strengths and are not to be used without applying the proper safety or resistance factor as shown above the top-right-hand corner of each table.
shear strength table indicating conditions where panel buckling could potentially govern over connector strength. Nominal ... 2-0 2-3 2-6 2-9 3-0 3-3 3-6 3-9 4-0 4 -34 -64 -11 0 0.454 1 0.337 2 0.269 3 0.223 4 0.191 5 0.167 6 0.148 0 0.567 1 0.396 2 0.305 3 0.247 4 0.208 ... Puddle Welds Thru 16 Gage Washer w/3/8" Hole Side Lap Fasteners: # 10 ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}