Transcription of TABLE OFToyota CONTENTS DigitalAmplifierInterface2001-2015
{{id}} {{{paragraph}}}
Example: marketing
TABLE OFToyota CONTENTS DigitalAmplifierInterface2001-2015
CAUTION! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running. TYTO-01 INSTALLATION COPYRIGHT 2017 METRA ELECTRONICS CORPORATION REV. 12/29/17 INSTTYTO-01 INTERFACE FEATURESINTERFACE COMPONENTSTOOLS REQUIRED Cutting tool Crimping tool Tape Connectors (example: butt-connectors, bell caps, etc.) TABLE OF CONTENTSC onnections to be made ..2-3 Installing the TYTO-01 ..3 Testing the TYTO-01 ..3 Toyota amplified interface 2001-up* Provides accessory power (12-volt 10-amp) Used in amplified systems High level speaker input USB updatable Retains balance and fade TYTO-01 interface 16-pin harness with stripped leads 14-pin to 20-pin harness with stripped leads*Visit for up-to-date vehicle specific inside front cover2 APPLICATIONSCONNECTIONS TO BE MADEL exusES330 2004-2006ES300 2002-2003IS300 2002-2005LS430 2001-2006RX330 2004-2006RX350 2007-2009RX400H 2006-2008SC430 2002-2010 Toyota4-Runner (excludes Urban Runner) 2003-upAvalon 2005-upCamry 2007-upCorolla 2005-2011FJ Cruiser 2011-upHighlander 2008-upMatrix 2005-2012 Prius 2004-2011 Prius (3rd gen/PHV) 2012-upRav4 2004-upSequoia 2005-upSienna 2004-upSolara 2004-2008 T
23˛˝˙ˆˆˇ˘ ˇ˘ ˆ ˙ ˆ 3 From the TYTO-01 harness to the aftermarket radio: • Connect the Black wire to the ground wire. • Connect the Yellow wire to the battery wire. • Connect the Red wire to the accessory wire. • Connect the Blue wire to the power antenna wire. • If the aftermarket radio has an illumination wire, connect the Orange wire to it.
Loading..
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: