Transcription of TECHNICAL BULLETIN TB-2000 ... - …
{{id}} {{{paragraph}}}
Example: air traffic controller
TECHNICAL BULLETIN TB-2000 ... - …
TB-2000 February 2015 Page 1 of 4 installation and maintenance of ESD MatsIntroductionThe purpose of an ESD worksurface is to aid in the prevention of damage to ESD sensitive components and assemblies from electrostatic discharge. An ESD worksurface provides protection in the following two ways:1. Providing an antistatic worksurface area that will limit static electricity generation. 2. Removing the charge from a conductive object placed on the worksurface. A dissipative worksurface having a surface resistance of at least 1 x 106, but less than 1 x 109 ohms is recommended by worksurface standard ANSI/ESD Dissipative materials minimize the generation of static charges, and will dissipate a charge slow enough so that a spark will not occur.
Installation and Maintenance of ESD Mats Introduction ... standard ANSI/ESD S4.1. Dissipative materials minimize the generation of static charges, and will dissipate a charge slow ... MA 02021-1407 • (781) 821-8370 • Web Site: Desco.com WRONG! RIGHT! Figure 8. Installing Universal Snap Kit on mat.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Protection of Electrostatic Discharge, Protection of Electrostatic Discharge Susceptible, Materials, Electrostatic Discharge, Model (HBM) for electrostatic, Model (HBM) for electrostatic discharge ESD, DESCO BAG SELECTION CHART, Reztore® Surface & Mat Cleaner, Wrist Strap Tester Installation, Operation and Maintenance, ESD Electrostatic Discharge Part 1, ESD training, Training