Three-phase motor driver - STMicroelectronics
Ipeak Pulsed output current (1) 1. Pulse width limited only by junction temperature and the transient thermal impedance. 5 A VSENSE Sensing voltage (DC voltage) -1 to 4 V Vboot Bootstrap peak voltage 62 V VOD Differential output voltage (between any of the 3 OUT pins) 60 V fC Commutation frequency 150 kHz VREF Reference voltage 12 V
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
Low-power dual operational amplifier - st.com
www.st.comFebruary 2016 DocID2471 Rev 17 1/24 This is information on a product in full production. www.st.com LM2904, LM2904A Low-power dual operational amplifier
AN3128 Application note - st.com
www.st.comJune 2011 Doc ID 16918 Rev 5 1/105 AN3128 Application note STM32 embedded graphic objects/touchscreen library Introduction This library is a firmware package which contains a collection of routines, data structures,
AN4767 Application note - st.com
www.st.comDocID028380 Rev 2 7/16 AN4767 Dual bank use cases 15 With dual bank, all the manipulation with the other bank is just another task of the main program.
AN3155 Application note - st.com
www.st.comOctober 2016 DocID17066 Rev 7 1/37 1 AN3155 Application note USART protocol used in the STM32 bootloader Introduction This application note describes the USART protocol used in the STM32 microcontroller
USB Power Delivery and Type-C - st.com
www.st.comUSB Type -C Overview USB Power Delivery specification introduces USB Type-C receptacle, plug and cable; they provide a smaller, thinner and more robust alternative to existing USB interconnect.
Datasheet - L78 - Positive voltage regulator ICs - …
www.st.comTO- 2 2 0 TO-2 2 0 F P DPAK D² PAK Features • Output current up to 1.5 A • Output voltages of 5; 6; 8; 8.5; 9; 12; 15; 18; 24 V • Thermal overload protection
AN2867 Application note - st.com
www.st.comMay 2017 DocID15287 Rev 11 1/43 1 AN2867 Application note Oscillator design guide for STM8AF/AL/S and STM32 microcontrollers Introduction Many designers know oscillators based on Pierce-Gate topology (hereinafter referred to as
AN4776 Application note - st.com
www.st.comMay 2017 DocID028459 Rev 2 1/73 1 AN4776 Application note General-purpose timer cookbook Introduction The timer peripheral is part of …
120-volt, 100-watt, DMOS audio amplifier with mute …
www.st.comSeptember 2010 Doc ID 6744 Rev 8 1/21 21 TDA7293 120-volt, 100-watt, DMOS audio amplifier with mute and standby Features Multipower BCD technology Very high operating voltage range (±50 V)
Electronic transformer for a 12V halogen lamp - …
www.st.comAPPLICATION NOTE AN528/0999 1/4 ELECTRONIC TRANSFORMER FOR A 12V HALOGEN LAMP by P. Fichera, R. Scollo 1. INTRODUCTION Lighting that uses halogen lamps is commonly found
Related documents
Basic Electronics - New York University
engineering.nyu.edupulsed DC. •A filter capacitor is used to smooth out the pulses. •Capacitor must be large enough to store sufficient charge so as to provide a steady current supply to the load: f is rectified signal’s frequency (120Hz). R C f Load 1/ Transistor • A three lead semiconductor device that acts as: ...
AO3400 Rev8 RoHS
aosmd.comPulsed Drain Current C Continuous Drain Current Gate-Source Voltage ±12 V Parameter Typ Max °C/W RθJA 70 100 90 TA=70°C 0.9 Junction and Storage Temperature Range -55 to 150 °C Thermal Characteristics Power Dissipation B PD TA=25°C …
MC34152 - MOSFET Driver, High Speed, Dual
www.onsemi.com80 s Pulsed Load Figure 11. Drive Output Rise Time Figure 12. Drive Output Fall Time 10 ns/DIV 10 ns/DIV 90% - 10% - VCC = 12 V Vin = 0 V to 5.0 V CL = 1.0 nF TA = 25°C VCC = 12 V Vin = 0 V to 5.0 V CL = 1.0 nF TA = 25°C, OUTPUT CLAMP VOLTAGE (V), …
Power MOSFET - Vishay Intertechnology
www.vishay.comPulsed diode forward current a ISM-- 80 Body diode voltage VSD TJ = 25 °C, IS = 20 A, VGS = 0 Vb-- 1.8V Body diode reverse recovery time trr TJ = 25 °C, IF = 20A, dI/dt = 100 A/μsb - 570 860 ns Body diode reverse recovery charge Qrr-5.7 8.6μC Forward turn-on time ton Intrinsic turn-on time is negligible (turn-on is dominated by LS and LD) D ...
Complementary low voltage transistor - STMicroelectronics
www.st.com1. Pulsed: pulse duration = 300 µs, duty cycle 1.5% Collector-emitter sustaining voltage (IB=0) NPN IC = 30 mA BD135 BD139 45 80 V V PNP IC = -30 mA BD136 BD140-45-80 V V VCE(sat) (1) Collector-emitter saturation voltage NPN IC = 0.5 A, IB = 0.05 A 0.5 V PNP IC = -0.5 A, IB = -0.05 A -0.5 V VBE (1) Base-emitter voltage NPN IC = 0.5 A, VCE = 2 ...
0 1 2 3 4 5 0 1 2 3 4 5 - BAUS
www.baus.org.ukThe I-PSS is based on the answers to seven questions concerning urinary symptoms. Each question is assigned points from 0 to 5 indicating increasing severity of the particular symptom.