Power 2 4 Ghz Rf Transceiver
Found 8 free book(s)
Single chip 2.4 GHz Transceiver nRF24L01
www.sparkfun.com• Uses low cost chip inductors and 2-layer PCB • Power supply range: 1.9 to 3.6 V GENERAL DESCRIPTION nRF24L01 is a single chip radio transceiver for the world wide 2.4 - 2.5 GHz ISM band. The transceiver consists of a fully integrated frequency synthesizer, a power
Datasheet - S2-LP - Ultra-low power, high performance, sub ...
www.st.comThe S2-LP is a high performance ultra-low power RF transceiver, intended for RF wireless applications in the sub-1 GHz band. It is designed to operate in both the license-free ISM and SRD frequency bands at 433, 512, 868 and 920 MHz, but can also be programmed to operate at other additional frequencies in the 413-479 MHz,
ALL MODE MULTI-BAND TRANSCEIVER TS-2000 TS-2000X …
www.kenwood.comTransceiver TS-2000X: HF/ VHF/ UHF/ 1.2 GHz All-mode Multi-band Transceiver TS-B2000: HF/ VHF/ UHF All-mode Multi-band Transceiver As for TS-B2000, refer to the on-line help for information on how to operate and control the transceiver. Refer to pages 2, 3, and 13 for the installation and information on the connectors. MARKET CODES K-type: The ...
RF Agile Transceiver Data Sheet AD9361 - Analog
www.analog.comRF 2 × 2 transceiver with integrated 12-bit DACs and ADCs TX band: 47 MHz to 6.0 GHz RX band: 70 MHz to 6.0 GHz Supports TDD and FDD operation Tunable channel bandwidth: <200 kHz to 56 MHz Dual receivers: 6 differential or 12 single-ended inputs Superior receiver sensitivity with a noise figure of 2 dB at 800 MHz LO RX gain control
RF Agile Transceiver Data Sheet AD9363 - Analog Devices
www.analog.comRadio frequency (RF) 2 × 2 transceiver with integrated 12 -bit DACs and ADCs Wide bandwidth: 325 MHz to 3.8 GHz . Supports time division duplex ( TDD) and frequency division duplex (FDD) operation . Tunable channel bandwidth (BW): up to 20 MHz . Receivers: 6 differential or 12 single …
EFR32MG13 Data Sheet: Mighty Gecko Multi-Protocol …
www.silabs.com• 2.4 GHz and Sub-GHz radio operation • Transmit power: • 2.4 GHz radio: Up to 19 dBm • Sub-GHz radio: Up to 20 dBm • Low Energy Consumption • 10.3 mA RX current at 250 kbps, DSSS-OQPSK, 2.4 GHz • 9.5 mA RX current at 1 Mbps, GFSK, 2.4 GHz • 8.4 mA RX current at 38.4 kbps, GFSK, 169 MHz • 8.5 mA TX current at 0 dBm output ...
BGM220P Wireless Gecko Bluetooth Module Data Sheet
www.silabs.com4.8 RF Receiver Characteristics for Bluetooth Low Energy in the 2.4 GHz Band 2 Mbps Data Rate...16 4.9 RF Receiver Characteristics for Bluetooth Low Energy in the 2.4 GHz Band 500 kbps Data Rate ..17 4.10 RF Receiver Characteristics for Bluetooth Low Energy in the 2.4 GHz Band 125 kbps Data Rate..18 4.11 High-Frequency Crystal .....19 4.12 Low ...
Preliminary Product Specification v1
www.sparkfun.comRevision 1.0 Page 8 of 75 nRF24L01+ Preliminary Product Specification 1.1 Features Features of the nRF24L01+ include: •Radio XWorldwide 2.4GHz ISM band operation X126 RF channels XCommon RX and TX interface XGFSK modulation X250kbps, 1 and 2Mbps air data rate X1MHz non-overlapping channel spacing at 1Mbps X2MHz non-overlapping channel spacing at 2Mbps