12-Volt Negative Ground Installation Instructions
12-Volt Negative Ground Installation Instructions Page 1 of 4 ATION Beore ta eae rea te oo mortat ormato 99-599-5955 www.pertronix.com 1. The Ignitor is designed for 12-olt negative ground systems.
Download 12-Volt Negative Ground Installation Instructions
Information
Domain:
Source:
Link to this page:
Documents from same domain
12-Volt Negative Ground Installation Instructions
www.pertronix.com15. If the gap is greater than 0.060” record what it is. The gap is adjusted by installing thin washers over the 6/32 studs between the magnet ring and advance mechanism plate.
ElEcTRonic igniTion - PerTronix Performance Products
www.pertronix.comAuDI 1970-72 4 90, 100LS Bosch 231167011, 045 33, 79 1847V 91847V 71847V 1972 4 Super 90 Bosch 231176014 33, 79 1847V 91847V 71847V 1973-74 4 Fox, 80LS Bosch 33, 79 1847V 91847V 71847V
12-Volt Negative Ground Installation Instructions
www.pertronix.comCOIL WIRE RED WIRE BLACK WIRE TO IGNITION COIL WIRE TO IGNITION SWITCH RED WIRE BLACK WIRE RESISTANCE WIRE BALLAST RESISTOR The Ignitor can also be installed in applications retaining the ballast resistor or resistance wire.
Related documents
KEYLESS ENTRY and ALARM SYSTEM …
www.crimestopper.com4 WIRING GREEN WIRE: (-) NEGATIVE DOOR TRIGGER Identify the wire that reads ground when any door is open and 12 volts when all doors are closed.
MSD 6 Series Installation Instructions 6A, 6AL, 6T, …
www.g3ignition.comAUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 † (915) 857-5200 † FAX (915) 857-3344 MSD 6 Series Installation Instructions 6A, 6AL, 6T, 6BTM, 6TN, 6ALN Parts Included: 1 - MSD 6 Series Ignition 1 - …
FLOWMETER INSTALLATION INSTRUCTIONS - …
www.livorsi.comFLOWMETER INSTALLATION INSTRUCTIONS - 2 - FLOWMETER WIRING CONNECTOR 1: Disconnect (-) negative battery cable before doing any electrical work.
INSTALLATION INSTRUCTIONS FOR PART 99-9700
www.metraonline.com99-9700 6 • Provides accessory power (12-volt 10-amp) • High level speaker input • Retains balance and fade • Retains oil pressure and EITMS status
12-Volt Negative Ground Installation Instructions
www.pertronix.com15. If the gap is greater than 0.060” record what it is. The gap is adjusted by installing thin washers over the 6/32 studs between the magnet ring and advance mechanism plate.
TECH SUPPORT 1-888-588-4506 ….WEB …
www.stealth1charging.com1 STEALTH I DC MANUAL TECH SUPPORT 1-888-588-4506 ….WEB www.stealth1charging.com BLACK UNIT IS 24/36 ONLY PLEASE READ AND UNDERSTAND YOUR NEW PRODUCT IMPORTANT MESSAGE: Before installing your newly purchased STEALTH I DC charging system be sure to read the following instructions …