American - Milgard
6.2 SIZING OF RETROFIT WINDOWS . 6.2.1 Accuracy of size is critical. Sizing shall allow for proper fit without having to rack or force the retrofit window into the rough opening. 6.2.2 The retrofit window shall be no less than 6 mm (1/4 in) less in width and height than the measurements of Section 6.1.2.
Download American - Milgard
Information
Domain:
Source:
Link to this page:
Documents from same domain
SLIDING GLASS DOOR ASSEMBLY AND …
www.milgard.comsliding glass door assembly and installation instructions ... before starting the installation ... the outside of the frame by inserting the top and swinging ...
Limited Warranty - Milgard
www.milgard.comcommercial purchaser of its multi-slide doors including, without limitation, stacking, bi-folding and pocket doors (the “Products”): • Workmanship and Materials: each Product shall be free of defects for a period of ten (10) years from the date of
Limited Warranty - Milgard
www.milgard.compurchaser of its multi-slide doors, including without limitation stacking, bi-folding and pocket doors (the “Products”): • Products (two years): each Product shall be free of defects for a period of two (2) years from the date of shipment
Performance Ratings - Milgard
www.milgard.comTuscany® Series Performance Ratings Updated: 8/2014 size bs/vs bs/vs bs/vs Half Vent 6050 -LC-PG-40 0.04 62 01 5 Double Vent 8060 - HS-LC-30 0.03 6 2 0 1 6 8 0 6 0 24 Double Vent 10050 36 HS-LC-25 0.1 6 3 0 3 0 10 0 5 0 36 Double Vent 13060 48 HS-R-15 0.1 6 3 0 1 6 12 13 0 6 0 48 Half Vent Below 6080 36 LC-PG-25 0.05 3.75/6.75 2 0 3 0 6 0 6 0 36 Half Vent Above 6080 36 LC-PG-25 0.03 3.75 2 …
Glass and Glazing - Milgard
www.milgard.comLaminated glass is produced by permanently bonding two pieces of glass together with a tough plastic interlayer (polyvinyl butyral) under heat and pressure. Once bonded together, the sandwich behaves as a single piece. The interlayer is invisible when viewed through the glass and with glass on either side, the finished lite is indistinguishable
Standard Practice for Installation of Windows with a ...
www.milgard.comThis practice addresses the recommended methods and/or sequences used to apply/modify the water-resistive barrier (WRB) or other ... 1.7 This practice is not intended to replace a manufacturer’s installation instructions or federal, state, or local building codes. In all ... and support system, but also on their proper installation. 2.2 ...
Related documents
Chapter 9: Column Analysis and Design
academic.csuohio.edu9.1 Chapter 9: Column Analysis and Design Introduction Columns are usually considered as vertical structural elements, but they can be positioned in any orientation (e.g. diagonal and horizontal compression elements in a
FLUORESCENT to LED RETROFIT INSTRUCTIONS
www.bmlighting.comTHIS RETROFIT ASSEMBLY IS AN APPROVED COMPONENT OF A LINEAR FLUORESCENT LUMINAIRE KIT WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL AUTHORITIES HAVING JURISDICTION. - For use only with UL and C-UL Listed surface mounted or recess mounted linear fluorescent luminaries with or without diffuser.
RETROFIT FOR THE FUTURE - GOV.UK
assets.publishing.service.gov.ukABOUT RETROFIT Retrofi t is the introduction of new materials, products and technologies into an existing building to reduce the energy needed to occupy that building. Retrofi t is not the same as renovation or refurbishment, which often make good, repair or …
ASCE 41-13: Seismic Evaluation and Retrofit Rehabilitation ...
nehrp.govretrofit design. Retrofit design is simply evaluating a building in an altered state and adjusting the alterations until the building’s evaluation meets the desire performance objective. Therefore there is no difference between a Tier 2 or Tier 3 evaluation or retrofit. The analysis procedures and acceptance criteria are the same.
LiftMaster MyQ | Installation Guide MyQ® Garage Universal ...
suretyhome.comCopyright © 2014 Alarm.com | www.alarm.com | v2.0 LiftMaster MyQ® | Installation Guide The Wi-Fi Hub will not operate the garage door opener. -Ensure the garage ...
Insp Affidavit reroofing hurricane mitigation retrofit
www.charlottecountyfl.govRoof/Re-Roof Hurricane Mitigation Retrofit Inspection Affidavit. Job Address: I, , am licensed as a Contractor*, Engineer, Architect, F.S. 468 Building inspector*. License #: On or about (date & time) , I did personally inspect the. Roof Deck Nailing, Roof to Wall Connections work at the above address.