Arduino - Tutorials - 4tronix
Simple Dimming 3 LEDs with Pulse-Width Modulation (PWM) More complex dimming/color crossfader Knight Rider example Shooting star PWM all of the digital pins in a sinewave pattern Digital Input Digital Input and Output (from ITP physcomp labs) Read a Pushbutton Using a pushbutton as a switch Read a Tilt Sensor Analog Input Read a Potentiometer
Download Arduino - Tutorials - 4tronix
Information
Domain:
Source:
Link to this page:
Related documents
TDA8954 2 × 210 W class-D power amplifier - NXP
www.nxp.comFor each channel, the audio input signal is co nverted into a digital Pulse Width Modulation (PWM) signal using an analog input stage and a PWM modulator; see Figure 1. To drive the output power transistors, the digital PWM signal is fed to a control and handshake block and to high- and low-side driver circuits .
AEROSEMI - Olimex
www.olimex.comThe MT3608 features automatic shifting to pulse frequency modulation mode at light loads. The MT3608 includes under-voltage lockout, current limiting, and thermal overload protection to prevent MT3608 is available in a small -pin SOT-23 6 package. Efficiency . Iout (mA) Figure 2. Efficiency Curve . Efficiency (%) GENERAL DESCRIPTION
Control-Mode Quick Reference Guide (Rev. A)
www.ti.comSimilar to COT control except a one-shot timer generates an on-time pulse that is proportional to the input voltage and the output voltage. When the falling feedback voltage equals the reference voltage, a new PWM on-pulse is generated. Fast response to load changes is achieved with a high-speed comparator in the control loop.
Time-of-Flight Camera – An Introduction - Texas Instruments
www.ti.commodulation frequency. Multi-frequency techniques work by adding one or more modulation frequencies to the mix. Each modulation frequency will have a different ambiguity distance, but true location is the one where the different frequencies agree. The frequency of when the two modulations agree, called the beat frequency, is usually lower, and
TBEN-L…-8IOL – IO-Link Master Module - TURCK
www.turck.de10 Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com 4 System Description IO-Link IO-Link is a fieldbus independent communication interface for sensors and actuators.
Data Formats for IR Remote Control - Vishay Intertechnology
www.vishay.comSeveral methods of modulation have become well established. A reliable and power saving transmission method in which bursts of the carrier frequency are transmitted is called “Pulse Co de Modulation” (PCM). There are three commonly used representations of one bit in remote control systems which ar e described in the following diagrams.