DigitalFlow™ GF868
Safety Issues Auxiliary Equipment Local Safety Standards The user must make sure that he operates all auxiliary equipment in accordance with local codes, standards, regulations, or laws applicable to safety. Working Area WARNING! Indicates a potentially hazardous situation which can result in serious personal injury or death, if it is not avoided.
Download DigitalFlow™ GF868
Information
Domain:
Source:
Link to this page:
Documents from same domain
Axial and Centrifugal Compressors Application Guide
dam.bakerhughesds.comcan be handled by this type of compressor with appropriate construction materials and seal systems. Pipeline – These compressors are specifically designed for pipeline compression stations. They are used for low and medium pressure ratio pipeline service and in recycle applications such as those performed in methanol plants, etc.
177230 Seismic Transmitter Datasheet - 177232
dam.bakerhughesds.comand SCADA systems that have internal power supplies which are typically current limited in the range of 30 mA to 35 mA. Settling Time Less than 15 seconds within 2% of final value Connector Wiring Convention n Pin A: 4-20 mA Positive Loop n Pin B: 4-20 mA Negative Loop and common for Dynamic Signal n Pin C:Dynamic Signal in voltage, unbuffered
Bently Nevada 3500 Monitoring System
dam.bakerhughesds.commonitoring platforms. Today, that experience is embodied in the most advanced, powerful, and reliable system we have ever offered: The Bently Nevada 3500 Series Machinery Protection System. Certified The 3500 is designed to fully comply with the American Petroleum Institute’s Standard API 670, the world’s most
2300 Series Vibration Monitors Datasheet - 105M0340
dam.bakerhughesds.comEN60079-15: 2010 EN60079-7: 2015 ATEX Directive 2014/34/EU RoHS RoHS Directive 2011/65/EU Hazardous Area Approvals For the detailed listing of country and product specific approvals, refer to the Approvals Quick Reference Guide (108M1756) available from Bently.com. CSA/NRTL/C Class I, Division 2/ Zone 2 AEx nA nC [ic] IIC T4 Gc
3500/92 Communication Gateway
dam.bakerhughesds.comModbus Based on AEG Modicon PI-MBUS-300 Reference Manual. Uses Remote Terminal Unit (RTU) transmission mode. Ethernet Communication Link Ethernet, 10Mbps, and conforms to IEEE802.3 Protocol Ethernet TCP/IP frame and Modbus/TCP Connection RJ-45 (telephone jack style) for 10BASE-T Ethernet cabling Environmental Limits Main and I/O Module
350022M Transient Data Interface Datasheet
dam.bakerhughesds.comHumidity 95%, non-condensing Battery Life Powered TDI 38 years @ 50°C (122°F) Unpowered TDI 12 years @ 50°C (122°F) Physical TDI Module Dimensions (Height x Width x Depth) 241.3 mm x 24.4 mm x 241.8 mm (9.50 in x 0.96 in x 9.52 in) Weight 0.91 kg (2.0 lbs) I/O Modules Dimensions (Height x Width x Depth) 241.3 mm x 24.4 mm x 99.1 mm
Related documents
HEALTH, SAFETY & ENVIRONMENTAL HANDBOOK
dtcenergygroup.comSAFETY RULES DTC Energy Group will enforce compliance of HSE policies and practices. Report all injuries, vehicle collisions, spills/environmental releases, near misses, fires, unsafe conditions and unsafe work practices to management. Hold a pre-job safety meeting to review procedures, equipment locations and emergency plans.
Workshop Self Inspection Checklist WORK01
www.docs.csg.ed.ac.ukreference to key HSE guidance in the area in question, which can be obtained from Health and Safety Department (514255; Health.Safety@ed.ac.uk). ADMINISTRATIVE PROCEDURES YES NO N/R What was the date of last formal inspection of the workshop? Have items which attracted an negative response in the former inspection been suitably addressed?
Risk Assessment and Method Statement - Health and Safety ...
protecting.co.ukThe use of electrical equipment will be monitored to ensure safe use. Only trained and competent persons test, repair and maintain portable electrical equipment Operator to ensure that correct PPE is worn for the task being undertaken i.e. goggles, ear defenders, gloves, safety footwear Hazard: General housekeeping
HEALTH, SAFETY AND ENVIRONMENT GUIDELINES
www.dmcc.aeand visit. This can be achieved only through world class standards in health, safety and environmental (HSE) performance. DMCC's excellent record on HSE has been achieved by working in partnership with Member Companies and residents as well as implementing robust rules and controls and careful auditing procedures.
Health and Safety in the Salon
www.gbmc.ac.ukHealth and safety policy A document outlining an employer’s policy and commitment to health and safety . Health and Safety Executive (HSE) The body that regulates health and safety and enforces authority : Accident An unplanned and uncontrolled event with the potential to cause injury . Hazard Something that has the potential to cause harm