INTRODUCTION USER’S MANUAL BASIC SAFETY …
• This CO Alarm alone is not a suitable substitute for complete detection systems in places which house many people, like hotels or dormitories, unless a CO Alarm is also placed in each unit. • DO NOT use this CO Alarm in warehouses, industrial or com-mercial buildings, special-purpose non-residential buildings, or airplanes.
Download INTRODUCTION USER’S MANUAL BASIC SAFETY …
Information
Domain:
Source:
Link to this page:
Documents from same domain
First Alert Talking Combination Smoke and Carbon Monoxide ...
www.firstalertstore.comThis user’s manual contains important information about your Combination Carbon Monoxide & Smoke Alarm’s operation. If you are installing this ... family living units. It is not designed to measure CO levels in ... audible and visual signals for carbon monoxide concentrations under 30 ppm. For additional information on carbon monoxide and ...
USER’S MANUAL INTRODUCTION Smoke & Carbon …
www.firstalertstore.comkeep carbon monoxide or smoke from reaching the Alarm. Installing Smoke/CO Alarms in Mobile Homes For minimum security install one Smoke/CO Alarm as close to each sleeping area as possible. For more security, put one unit in each room. ... (6 meter) distance is not possible – in modular, mobile, or smaller
USER’S MANUAL Smoke Alarms - FirstAlertStore.com
www.firstalertstore.comSmoke Alarms that do not work cannot alert you to a fire. Keep at least one working fire extinguisher on every floor, and an addi-tional one in the kitchen. Have fire escape ladders or other reliable means of escape from an upper floor in case stairs are blocked.
Hardwired Photoelectric Smoke Alarm with Battery Backup
www.firstalertstore.comModel 7010B Only:Activate the battery back-up by removing the “Pull to Activate Battery Back-Up” tab. Or, install battery back-up. Battery back-up cannot work until you install the battery in the correct position (Match “+” to “+” and “-” to “-”). Push and hold test button until the alarm sounds: 3 beeps, pause, 3 beeps ...
USER’S MANUAL Smoke Alarms
www.firstalertstore.com• This Smoke Alarm must have AC or battery power to operate. If the AC power fails, battery back-up will allow the alarm to sound for at least 4 minutes. If AC power fails and the battery is weak, protection should last for up to 7 days. If AC power fails and the battery is dead or missing, the alarm cannot operate.
INSTALLATION HOW TO INSTALL THIS SMOKE/CO ALARM …
www.firstalertstore.comThis Smoke/CO Alarm is designed to be mounted on any standard wiring junction box up to a 4-inch (10 cm) size, on either the ceiling or wall (if allowed by local codes). Read “Where to Install This Alarm” and “Where This Alarm Should Not Be Installed” before you begin installation.
INTRODUCTION USER’S MANUAL FIRE SAFETY TIPS …
www.firstalertstore.com• This Smoke/CO Alarm is approved for use in single-family residences. It is NOT designed for marine or RV use. • This combination Smoke/Carbon Monoxide Alarm has two separate alarms. The CO Alarm is not designed to detect fire or any other gas. It will only indicate the presence of carbon monoxide gas at the sensor.
Related documents
TESTING, INSPECTION AND MAINTENANCE OF FIRE ALARM …
www.health.state.mn.uso If not kept at the main fire alarm control unit, the location of these documents must be identified at the main fire alarm control unit see NFPA 72(10), Sec. 10.18.2.1.2.7. The enclosure or cabinet in which– the documents are stored must be prominently labeled FIRE ALARM DOCUMENTS – see NFPA 72(10), Sec. 10.18.2.1.2.8.
NFPA 72 Fire Alarm Inspection and Testing Requirements 1.6 ...
recimi.wildapricot.org14 Fire Safety Consultants, Inc. 27 Fire Alarm System - Testing 14.4 – Testing • 14.4.1.2 – Reacceptance Testing • Changes to site-specific software require: 100% test of all functions known to be affected by the change Additionally, 10% of initiating devices that are not directly affected by the change (up to 50 devices) shall be tested to verify correct system operation
Combo Smoke/CO Alarm User’s Guide - Kidde Fire Safety ...
www.kidde.complay with the unit. This Kidde Smoke/CO Alarm was designed to detect both smoke and carbon monoxide from any source of combustion in a residential environ-ment. It is not designed for use in a recreational vehicle (RV) or boat. P/N: 2534-7201 RevA For your convenience, write down the following information. If you
Building Fire Safety - Queensland Fire and Emergency Services
www.qfes.qld.gov.auIs the Fire Detection and Alarm System operating with ... Are fire safety standards available for inspection ... row house, terrace house, town house or villa unit, Class 1b a boarding/guest house or hostel not exceeding 300m² in which not more than 12 people reside,
PEMBROKE ELECTRIC FIREPLACE
images.thdstatic.comlevel with the Unit Anchor, and attach with two Anchor Screws using a Philips Screwdriver. On the Anchor Tether, detach the cable from the connector and loop the loose cable through the eyelets on the Wall Anchor and Unit Anchor. Reattach the loose cable to the connector, but do not tighten. Locate a secure wall stud behind the unit closest to the