INSTALLATION HOW TO INSTALL THIS SMOKE/CO ALARM …
This Smoke/CO Alarm is designed to be mounted on any standard wiring junction box up to a 4-inch (10 cm) size, on either the ceiling or wall (if allowed by local codes). Read “Where to Install This Alarm” and “Where This Alarm Should Not Be Installed” before you begin installation.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
INTRODUCTION USER’S MANUAL FIRE SAFETY TIPS …
www.firstalertstore.com• This Smoke/CO Alarm is approved for use in single-family residences. It is NOT designed for marine or RV use. • This combination Smoke/Carbon Monoxide Alarm has two separate alarms. The CO Alarm is not designed to detect fire or any other gas. It will only indicate the presence of carbon monoxide gas at the sensor.
USER’S MANUAL Smoke Alarms
www.firstalertstore.com• This Smoke Alarm must have AC or battery power to operate. If the AC power fails, battery back-up will allow the alarm to sound for at least 4 minutes. If AC power fails and the battery is weak, protection should last for up to 7 days. If AC power fails and the battery is dead or missing, the alarm cannot operate.
USER’S MANUAL INTRODUCTION Smoke & Carbon …
www.firstalertstore.comkeep carbon monoxide or smoke from reaching the Alarm. Installing Smoke/CO Alarms in Mobile Homes For minimum security install one Smoke/CO Alarm as close to each sleeping area as possible. For more security, put one unit in each room. ... (6 meter) distance is not possible – in modular, mobile, or smaller
First Alert Basic Plug-In Carbon Monoxide Alarm
www.firstalertstore.comdetect carbon monoxide from ANY source of combustion. It is NOT designed to detect smoke, fire, or any other gas. • This CO Alarm is approved for use in single-family residences. • This CO Alarm will only indicate the presence of carbon monoxide gas at the sensor. Carbon monoxide gas may be present in other areas.
USER’S MANUAL Smoke Alarms - FirstAlertStore.com
www.firstalertstore.comSmoke Alarms that do not work cannot alert you to a fire. Keep at least one working fire extinguisher on every floor, and an addi-tional one in the kitchen. Have fire escape ladders or other reliable means of escape from an upper floor in case stairs are blocked.
Hardwired Photoelectric Smoke Alarm with Battery Backup
www.firstalertstore.comModel 7010B Only:Activate the battery back-up by removing the “Pull to Activate Battery Back-Up” tab. Or, install battery back-up. Battery back-up cannot work until you install the battery in the correct position (Match “+” to “+” and “-” to “-”). Push and hold test button until the alarm sounds: 3 beeps, pause, 3 beeps ...
First Alert Talking Combination Smoke and Carbon Monoxide ...
www.firstalertstore.comThis user’s manual contains important information about your Combination Carbon Monoxide & Smoke Alarm’s operation. If you are installing this ... family living units. It is not designed to measure CO levels in ... audible and visual signals for carbon monoxide concentrations under 30 ppm. For additional information on carbon monoxide and ...
Related documents
Info Sheet - Smoke Alarm Installation
www.qfes.qld.gov.auSMOKE ALARM INSTALLATION Reasons behind prescribed locations Every residence is different and you will need to assess your home. To maximise smoke alarm operation, avoid installation in the following positions: » In dead air space. This is an area in which trapped hot air will prevent smoke from reaching the alarm.
Accenta Optima Honeywell Intruder Alarm installation manual
www.centralproperties.co.ukInstallation Installation Design The purchase of this alarm system represents a major step forward in the protection of the property and its occupants. It is important to plan the installation before proceeding following the procedures and advice contained in this manual. Plan the position of each part of the alarm system and the cable runs ...
Installation, Lamar, Installation installation, Alarm installation
IFC/NFPA/NEC Guide to Fire Alarm Wiring & Box Installations
www.prospertx.gov(1) The installation of all fire detection and fire alarm devices or systems, including monitoring equipment, subject to Insurance Code Chapter 6002 must be performed by or under the direct on -site supervision of a licensed fire alarm technician, residential fire alarm technician, residential fire alarm superintendent, or a fire
FIRE ALARM SYSTEM CHECK LIST - NC
files.nc.govFire alarm control unit (FACU) is powered up and clear of alarms, supervisory signals, and trouble ... Record battery size and verify date of installation is marked on each battery (Marking of the date of manufacture of the battery is a code requirement – so you will find 2 dates)
System, Installation, Lists, Fire, Check, Lamar, Fire alarm system check list
INSTALLATION MANUAL - Nittan
www.nittan.comThis manual explains, in a step-by-step manner, the procedure for the installation of the Nittan evolution 1 Fire Alarm Control Panel. This Installation Manual must not be left accessible to the User. 1.6 FIRE ALARM SYSTEMS CODE OF PRACTICE This manual is not designed to teach Fire Alarm System design.
Smoke Alarm User’s Guide
www.kidde.com• When mounting an alarm on the ceiling, locate it at a minimum of 4” (10 cm) from the side wall. • When mounting the alarm on the wall, use an inside wall with the top edge of the alarm at a minimum of 4” (10 cm) and a maximum of 12” (30.5 cm) below the ceiling. • Put smoke alarms at both ends of a bedroom hallway or large room if the
Fire Alarm System Inspection Check List
www.fpoa.bc.caFire Alarm System Inspection Check List The purpose of this checklist is to give the inspector a quick and easy guideline to follow when he or she is conducting a final inspection of a newly installed Fire Alarm …