INTRODUCTION USER’S MANUAL FIRE SAFETY TIPS …
• This Smoke/CO Alarm is approved for use in single-family residences. It is NOT designed for marine or RV use. • This combination Smoke/Carbon Monoxide Alarm has two separate alarms. The CO Alarm is not designed to detect fire or any other gas. It will only indicate the presence of carbon monoxide gas at the sensor.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
USER’S MANUAL Smoke Alarms - FirstAlertStore.com
www.firstalertstore.comSmoke Alarms that do not work cannot alert you to a fire. Keep at least one working fire extinguisher on every floor, and an addi-tional one in the kitchen. Have fire escape ladders or other reliable means of escape from an upper floor in case stairs are blocked.
First Alert Basic Plug-In Carbon Monoxide Alarm
www.firstalertstore.comdetect carbon monoxide from ANY source of combustion. It is NOT designed to detect smoke, fire, or any other gas. • This CO Alarm is approved for use in single-family residences. • This CO Alarm will only indicate the presence of carbon monoxide gas at the sensor. Carbon monoxide gas may be present in other areas.
USER’S MANUAL Smoke Alarms
www.firstalertstore.com• This Smoke Alarm must have AC or battery power to operate. If the AC power fails, battery back-up will allow the alarm to sound for at least 4 minutes. If AC power fails and the battery is weak, protection should last for up to 7 days. If AC power fails and the battery is dead or missing, the alarm cannot operate.
INSTALLATION HOW TO INSTALL THIS SMOKE/CO ALARM …
www.firstalertstore.comThis Smoke/CO Alarm is designed to be mounted on any standard wiring junction box up to a 4-inch (10 cm) size, on either the ceiling or wall (if allowed by local codes). Read “Where to Install This Alarm” and “Where This Alarm Should Not Be Installed” before you begin installation.
USER’S MANUAL INTRODUCTION Smoke & Carbon …
www.firstalertstore.comkeep carbon monoxide or smoke from reaching the Alarm. Installing Smoke/CO Alarms in Mobile Homes For minimum security install one Smoke/CO Alarm as close to each sleeping area as possible. For more security, put one unit in each room. ... (6 meter) distance is not possible – in modular, mobile, or smaller
Hardwired Photoelectric Smoke Alarm with Battery Backup
www.firstalertstore.comModel 7010B Only:Activate the battery back-up by removing the “Pull to Activate Battery Back-Up” tab. Or, install battery back-up. Battery back-up cannot work until you install the battery in the correct position (Match “+” to “+” and “-” to “-”). Push and hold test button until the alarm sounds: 3 beeps, pause, 3 beeps ...
First Alert Talking Combination Smoke and Carbon Monoxide ...
www.firstalertstore.comThis user’s manual contains important information about your Combination Carbon Monoxide & Smoke Alarm’s operation. If you are installing this ... family living units. It is not designed to measure CO levels in ... audible and visual signals for carbon monoxide concentrations under 30 ppm. For additional information on carbon monoxide and ...
Related documents
GENERAL RULES AND REGULATIONS FOR ELEMENTARY …
www.newman.esu8.orgstudent makes the trip. Any student failing to comply with rules and regulations while on the field trip shall be subject to discipline. FIRE DRILLS (Signal: Continuous Bells) The alarm will be sounded without your knowing in advance. You are to walk quickly, but orderly, down the stairs or fire escape and out of the building.
Fire Alarm Control Panel NFS-320/E/C, NFS-320SYS/E
advancedsecurity.usJun 16, 2011 · hear a fire alarm signal, do not respond or comprehend the meaning of the signal. It is the property owner's responsi-bility to conduct fire drills and other training exercise to make people aware of fire alarm signals and instruct them on the proper reaction to alarm signals. • In rare instances, the sounding of a warning device can
Safety & Health Core Rules, Chapter 296-800 WAC
www.lni.wa.govSafety and Health Core Rules _____ Chapter 296-800 WAC Safety & Health Core Rules (Form Number F414-059-000) This book contains the Safety & Health Core Rules, as adopted under the Washington Industrial Safety and Health Act of 1973 (Chapter 49.17 RCW). The rules in this book are effective October 2021. A brief promulgation history, set within
This book is provided to the public for free by the FDNY.
www1.nyc.govout-of-service fire protection system. A fire guard must be available to patrol all areas in which the fire protection system is out of service at least onceevery hour. No individual fire guard must patrol more than 50,000 square feet of building floor area. f coverageI area is over 50,000 sq. ft. more than 1 fire guard must be assigned.
Digital Life User Guide
my-digitallife.att.comJan 30, 2015 · WARNING: The battery(ies) used in each device may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble, heat above 100°C (212°F) or dispose of in fire. Replace battery(ies) with specified manufacturer batteries only. Use of another battery(ies) may present a risk of fire or explosion." System Test
Installation Manual
www.eltek.comMay 26, 2010 · Alarm contacts are rated for a maximum voltage of 60 V, SELV (Safety Extra Low Voltage) and a maximum continuous current of 0.5A. Connection and mounting torque requirements are listed in Table 6. Heat dissipation greater than the objectives listed in GR-63-CORE may occur. Additional equipment room cooling may be required.