METER LOOP SPECIFICATIONS FOR SINGLE PHASE SERVICE
MANUFACTURED HOMES, MOBILE HOMES OR PORTABLE BUILDINGS. These specifications contain guidelines for meter loops, both overhead and underground service extensions. Several examples of meter loop constructions are shown on drawings in these specifications. These specifications are for meter loops rated 200 amps or less.
Download METER LOOP SPECIFICATIONS FOR SINGLE PHASE SERVICE
Information
Domain:
Source:
Link to this page:
Documents from same domain
METER LOOP SPECIFICATIONS FOR SINGLE PHASE …
www.samhouston.netMETER LOOP SPECIFICATIONS FOR SINGLE PHASE SERVICE (Effective June 1, 2010) As required by: Sam Houston Electric Cooperative, Inc. Address: P.O. Box 1121 1157 E. Church St.
Related documents
Owner's Manual and Installation Instructions
c.searspartsdirect.com• This dryer is manufactured with a 3-wire, cabinet-ground conductor con-nected to the NEUTRAL (white or cen-ter wire) of the wiring harness at the terminal block. • Use a 4-wire conductor cord when the dryer is installed in a mobile home or an area where local codes do not per-mit grounding through the neutral.
SETTING UP A MANUFACTURED HOME IN RICHLAND …
richlandcountysc.govDOCUMENTS REQUIRED FOR SET-UP IN A MOBILE HOME PARK 1. Ownership or sales paperwork for the manufactured home. 2. Moving permit is required even if the manufactured home is being moved within the mobile home park where it is presently located. 3. The name, address and lot number of the mobile home park where the manufactured home is to be located.
INFORMATION AND REQUIREMENTS FOR ELECTRIC …
www.eversource.comINFORMATION AND REQUIREMENTS FOR ELECTRIC SUPPLY BELOW 600 VOLTS This publication supersedes similar publications previously issued by the Northeast Utilities System.
Product Data
www.aireclima.comNEW HOMES The model 58MCB combines high efficiency with flexibility to ... manufactured (mobile) home when the optional kit is used. Refer ... FUSE 3-AMP 0.5 AMP@24VAC HUM TEST/TWIN G Com W Y R 24V 120 180 90 150 BLOWER OFF-DELAY PLT 1 COOL HEAT SPARE-1 SPARE-2 EAC-1 1-AMP@ ...
2020 NEC Changes
www.dli.mn.govAll services supplying dwelling units (including mobile or manufactured homes) are required to be provided with a Type 1 or Type 2 surge‐protective device (SPD). The SPD must be an integral part of the service equipment or located immediately adjacent to the service equipment. This new
ELECTRIC DRYER INSTALLATION INSTRUCTIONS
www.whirlpool.com1996, (2) mobile homes, (3) recreational vehicles, and (4) areas where local codes prohibit grounding through the neutral conductors. If using a power supply cord: Use a UL-listed power supply cord kit marked for use with clothes dryers. The kit should contain: A UL-listed 30-amp power supply cord, rated 120/240 volt minimum.
REQUIREMENTS FOR MOBILE HOME SETUP
ocfl.netVehicles for new and used mobile/manufactured homes or park trailers. (1) Anchors: (a) Type I anchor holding power for homes manufactured before July 13, 1994, shall be tested to a working load of three thousand one hundred fifty (3,150) pounds, with an ultimate load of four thousand seven hundred twenty-five (4,725) pounds.
Electric Service Guidelines - MTE
mte.comD. Manufactured and Modular Home Services: 1. A red HUD label identifies manufactured or mobile homes. Meters may not be installed on manufactured or mobile homes. See ESG-4 or ESG-5 for specification details. 2. Modular homes are identified by a green State of Tennessee label. Services fo r modular homes may be identical to
HUDs Model Installation Standards for Manufactured …
iccsafe.org•22 million Americans live in manufactured homes •In 2011, manufactured housing accounted for: - 71% of all new homes sold under $125,000 - 50% of all new homes sold under $150,000 - 30% of all new homes sold under $200,000 •Manufactured housing industry is an important economic engine, accounting for about 38,000 jobs 18
INSTALLATION INSTRUCTIONS 30 (76 CM) …
www.whirlpool.combranch-circuit installations (1996 NEC); mobile homes; and recreational vehicles, or an area where local codes prohibit grounding through the neutral conductor. When a 4-wire receptacle of NEMA Type 14-50R is used, a matching UL listed, 4-wire, 250-volt, 40- or 50-amp, range power supply cord (pigtail) must be used. This cord contains 4 copper
Related search queries
S Manual and Installation Instructions, Manufactured, Mobile, A MANUFACTURED HOME IN RICHLAND, INFORMATION AND REQUIREMENTS FOR ELECTRIC, INFORMATION AND REQUIREMENTS FOR ELECTRIC SUPPLY BELOW, Homes, 2020 NEC Changes, Manufactured homes, INSTALLATION INSTRUCTIONS, Mobile homes, Homes manufactured, Model Installation Standards for Manufactured, INSTALLATION INSTRUCTIONS 30 (76 CM)