OWNER’S GUIDE & INSTALLATION INSTRUCTIONS
Installation Cored fiberglass hull—Follow separate instructions on page 4. CAUTION: The base must be liquid-tight.To ensure a tight bond, the hull surface under and around the base must be smooth, free of paint or any other finish, clean, and dry.
Download OWNER’S GUIDE & INSTALLATION INSTRUCTIONS
Information
Domain:
Source:
Link to this page:
Documents from same domain
OWNER’S GUIDE & INSTALLATION INSTRUCTIONS
www.airmartechnology.com2 Figure 5. Fairing Figure 6. Fairing NOTE: After the fairing is cut, the section with the cutting guide becomes the backing block. 20mm (3/4") cutting guide cavity for 22° max
OWNER’S GUIDE & INSTALLATION INSTRUCTIONS
www.airmartechnology.cominstallation on the starboard side of the boat or away from you for installation on the port side (Figure 4). 4.Adjust the cutting fence, so the fairing will be cut in about two
Getting to the Bottom of CHIRP Technology - Airmar
www.airmartechnology.comGetting to the Bottom of CHIRP Technology Jen Matsis Vice President - Sales & Marketing AIRMAR Technology
Related documents
Planing Hulls How do Hydrodynamics relate to planing of a ...
www.navaldesign.co.zaPlaning Hulls . In my previous article, I briefly discussed and touched on the different hull shapes available, how they work and how to distinguish these hull forms from one another.
Understanding design and performance of Stepped Hulls
www.navaldesign.co.zaUnderstanding design and performance of Stepped Hulls . So many readers have asked me about “Stepped Hulls” and with this in mind, I thought it might be a …
Marine Engines Application and Installation Guide
www.propellerpages.comMarine Engines Application and Installation Guide Engine Performance Boat Performance LEKM7142-01 (Supersedes LEKM7142) (05-00)
Westlawn Institute of Marine Technology
www.westlawn.eduWestlawn Institute of Marine Technology www.westlawn.edu Yacht & Boat Design Program Course Objectives and Syllabi Course # Module 1 Principles of Small Craft Naval Architecture