RS485 & Modbus Protocol Guide
RS485 or EIA (Electronic Industries Association) RS485 is a balanced line, half-duplex transmission system allowing transmission distances of up to 1.2 km. The following table summarises the RS-485 Standard: PARAMETER Mode of Operation Differential Number of Drivers and Receivers 32 Drivers, 32 Receivers Maximum cable length (metres) 1200
Download RS485 & Modbus Protocol Guide
Information
Domain:
Source:
Link to this page:
Documents from same domain
1) What is a transformer and how does it work?
www.cromptonusa.com4) Can transformers be operated at voltages other than nameplate voltages? In some cases, transformers can be operated at voltages below the nameplate rated
Installation and Operating Instructions R.O.C.O.F ...
www.cromptonusa.comCrompton R.O.C.O.F Protection Relay Embedded Generator Protection Installation & Operating Instructions Type 256-ROCL & Type 246-ROCL Crompton Instruments
Current Transformers - Te Connectivity
www.cromptonusa.comSummary CT's are inexpensive, accurate devices for monitoring current. If properly sized and installed, they will give many years of trouble free …
Copper wire figures - Te Connectivity
www.cromptonusa.comResistivities at room temp: Element Electrical resistivity (microohm-cm) Aluminum 2.655 Copper 1.678 Gold 2.24 Silver 1.586
Energy Division - Te Connectivity
www.cromptonusa.com1 Protector Trip Relays An extensive range of electronic control products providing continuous monitoring and protection of any electrical parameter.
TRANSFORMER TYPES - Te Connectivity
www.cromptonusa.comPotential transformers can be used with voltmeters for voltage measurements or they can be used in combination with current transformers for watt-meter or watt-
Watts, Vars and VA - Te Connectivity
www.cromptonusa.comVA, 0.8 PF load connected, the real power output of the inverter is only 4000 watts. In this scenario, the capacity of the inverter is fully utilized, and
Integra 1630 Low Profile Digital Metering System
www.cromptonusa.comDIN Integra 1630 Series Operation The multifunction Integra 1630 digital metering system offers uncomplicated operation and high accuracy measurement of three-phase voltage, current, frequency, Watts, VAr,
TN Neutral Current - Te Connectivity
www.cromptonusa.comUnbalanced Loads On a three-phase system where the dominant loads are single phase, the neutral carries the unbalanced amount of current. Even though the loads may have been balanced at one time, the
Installation instructions Analogue DIN Panel Meters
www.cromptonusa.comAnalogue DIN Panel Meters Products Covered (part number is prefixed with “E” for Eurodin) Caution: Risk of Danger These instructions contain ... This unit has been designed to provide protection against EM (electro-magnetic) interference in line with requirements of CE and other regulations. Precautions necessary to provide proper operation ...
Related documents
Wiring RS-485 Networks - Power Rich System
www.powerrichsystem.comRS-485 is used to implement KeyMaster networks, which link the access control system elements. KeyMaster systems consist of controller devices and reader devices connected in half-duplex, multidrop, RS-485 networks. This document serves as a guide to wiring Controlsoft RS-485 networks. It forms part of a set
PL-2303HX Edition (Chip Rev D) USB to Serial ... - Prolific
www.prolific.com.twRS232 / RS-422 / RS-485 Like Serial Interface Engine 256-Bytes OTP ROM Hardware ROM Default Descriptor PL-2303HXD RS-232/RS-422/RS-485 Like Interface USB Host Figure 2-1 Block Diagram of PL-2303HX (Rev D)
MAX13487E/MAX13488E Half-Duplex RS-485-/RS-422- …
datasheets.maximintegrated.comMAX13487E/MAX13488E Half-Duplex RS-485-/RS-422-Compatible Transceiver with AutoDirection Control www.maximintegrated.com Maxim Integrated | 3 Electrical Characteristics (continued) (VCC = +5V ±5%, TA = TMIN to TMAX, unless otherwise noted. Typical values are at VCC = +5V and TA = +25°C.) (Note 1) PARAMETER SYMBOL CONDITIONS MIN TYP MAX …
UniFi PoE Switch Datasheet - Ubiquiti
dl.ubnt.comDimensions 485 x 43.7 x 285.4 mm (19.09 x 1.72 x 11.24") Weight 4.8 kg (10.6 lb) Networking Interfaces (24) 10/100/1000 Mbps RJ45 Ethernet Ports (2) 1 Gbps SFP Ethernet Ports Management Interface (1) RJ45 Serial Port Out-of-Band, Ethernet In-Band Total Non-Blocking Throughput 26 Gbps Switching Capacity 52 Gbps Forwarding Rate 38.69 Mpps
SC16IS740/750/760 Single UART with I2C-bus/SPI ... - NXP
www.nxp.comhardware and software flow control, automatic RS-485 support, and software reset. This allows the software to reset the UART at any moment, independent of the hardware reset signal. 2. Features and benefits 2.1 General features Single full-duplex UART Selectable I2C-bus or SPI interface 3.3 V or 2.5 V operation
±15 kV ESD-Protected, 3.3 V,12 Mbps, EIA RS-485/RS-422 ...
www.analog.com±15 kV ESD protection, suitable for half-duplex communi-cation on multipoint bus transmission lines. The ADM3485E is designed for balanced data transmission and complies with TIA/EIA standards RS485 and RS-422. The ADM3485E is a half-duplex transceiver that shares differential lines and has separate enable inputs for the driver and the receiver.
The Basics of RS-232/422/485 - MOXA
www.moxa.siRS-485 uses half-duplex transmission, which means that transmission and reception share the same data channels. For this reason, only one transmitter can be active at any given time. Moxa’s serial boards have a built-in circuitry to switch transmitters on and off automatically. We call this form of switching ADDC®