Technical Guide: DensArmor Plus® High-Performance Interior ...
10, the highest level of performance for mold resistance under the ASTM D3273 test method, a testing method set by ASTM International, which develops testing guidelines and procedures for building materials, products, systems and services. The score of 10, in the ASTM D3273 test, indicates no mold growth in a 4-week controlled laboratory test.
Download Technical Guide: DensArmor Plus® High-Performance Interior ...
Information
Domain:
Source:
Link to this page:
Documents from same domain
TECHNICAL GUIDE - Georgia-Pacific Building Products
www.buildgp.cominstallation. DensGlass Sheathing is the ideal substrate for a wide variety of air and water-resistive barriers including building wraps, fluid applied coatings, self-adhering membranes and spray foam applications. See page 10 for details. Easy to Handle DensGlass Sheathing is lightweight and easy to handle.
SHAFTLINER FOR SHAFTWALL/STAIRWELL SYSTEMS
www.buildgp.comNote that the edges of the panel are beveled to help guide the panel into the slotted and tabbed section of the stud. 6. Progressively install succeeding studs and panels as described above until the wall section is enclosed. The final panel section may be secured with 1-5/8” (41 mm) Type S screws or tabs from the J track at 24” (610 mm) o ...
TECHNICAL GUIDE - Gypsum, Wood, Lumber, OSB Boards
www.buildgp.comDec 01, 2017 · The unique construction has been shown to withstand delamination, deterioration, warping and job site damage far more effectively than paper-faced gypsum board and other conventional roofing products such as wood fiberboard and perlite. • Provides superior fire protection. • Resists fire and hail damage.
Technical Service Hotline 1.800.225.6119 or www.gpgypsum
www.buildgp.comassembly installation instructions). Primary Uses Because of the superior performance of DensGlass Sheathing, it is specified for exterior walls, ceilings and soffits in a wide variety of applications. These include exterior insulation and finish systems (EIFS); cavity brick or stone veneer applications;
Densglass Shaftliner Area Walls Technical Guide
www.buildgp.comBuilding Code (IBC) Section 706, “Fire Walls.” The Area Separation Wall assembly using DensGlass Shaftliner panels is listed in the UL Fire Resistance Directory under UL Design U373 or U375, the ULC Fire Resistance Directory ULC Design No. W312 and the
Stamps/Signatures
www.buildgp.comFIRE SAFETY CAUTION Passing a fire test in a controlled laboratory setting and/or certifying or labeling a product as having a one-hour, two-hour, or any other fire resistance or protection rating and, therefore, as acceptable for use in certain …
DensShield® Tile Backer Installation Instructions
www.buildgp.comDS001. Note: Shower pan or rubber membrane must be adequately sloped to the open drain or weep hole detail to permit proper water drainage. Leave a 1⁄89 (3 mm) gap between DensShield Tile Backer and the shower pan. • DensShield Tile Backer is not to be used in shower curbs. • DensShield Tile Backer panels can be installed in the shower
Technical Service Hotline 1.800.225.6119 or www.densdeck
www.buildgp.commanufacturer’s specifications for full mopping applications and temperature requirements. ... * Testing was done in accordance with FM approvals 4470, Appendix C: Small Scale Tests, Membrane ... with the ANSI/UL 1256 Steiner Tunnel test. For additional information concerning
Related documents
STANDARD OPERATING PROCEDURES FOR MOLD …
www.ehs.wvu.eduPROCEDURES FOR MOLD REMEDIATION Origination Date – August 2013. West Virginia University ... Cleanup and Mold remediation Standard Operating Procedure (SOP) o U.S. Environmental Protection Agency. Mold Remediation in …
SHAFTLINER FOR SHAFTWALL/STAIRWELL SYSTEMS
www.buildgp.cominstead of paper facings, resists mold growth. The microbial-resistant test is based on ASTM D6329, a testing standard set by ASTM International, an agency which develops testing guidelines and procedures for building materials, products, systems and services. DensGlass® Shaftliner ©2016 Georgia-Pacific Gypsum LLC Fiberglass Mats Moisture ...