VSR - Potter Electric: Fire Alarms & Fire Sprinkler Systems
sizes 2" - 6" and is UL Listed and FM Approved for use on steel pipe; schedules 10 through 40, sizes 2" thru 8" (50 mm thru 200 mm). LPC approved sizes are 2" thru 8" (50 mm thru 200 mm). See Ordering Information chart. The VSR may also be used as a …
Download VSR - Potter Electric: Fire Alarms & Fire Sprinkler Systems
Information
Domain:
Source:
Link to this page:
Documents from same domain
SH-120 SERIES - Potter Electric Signal Company, LLC
www.pottersignal.comMKT. #8910015 - REV B 7/10 PRINTED IN USA PAGE 1 OF 2 SH-120 SERIES WALL MOUNT WEATHER PROOF SELECT-A-STROBE/HORN® Potter Electric Signal Co., LLC • St. Louis, MO • Cust Service: 866-240-1870 • Tech Support:866-956-1211• Canada 888-882-1833 • www.pottersignal.com
Features - Potter Electric Signal Company, LLC
www.pottersignal.comPAGE 3 OF 4 otter lectric Signal Compan, LLC • St Louis, • one -2- • wwwpottersignalcom 24 24 eletale andela toe ontoes 4-RV C S-24 24 VDC Selectable Candela, Low Profile Evacuation Strobe
ODC-59 SERIES - Potter Electric Signal Company, LLC
www.pottersignal.comODC-59 SERIES OVERHEAD DOOR CONTACT Potter Electric Signal Co., LLC • St. Louis, MO • Cust Service: 866-240-1870 • Tech Support: 866-956-1211 • Canada 888-882-1833 • www.pottersignal.com
Advanced Fire Training Manual - Potter Electric: Fire ...
www.pottersignal.comThe first standards for fire detection and alarm systems in the United States dates back to the 1800s. While these first fire alarms were simplistic, advances in technology have resulted in fire alarm systems that can be intimidating in their complexity.
Features
www.pottersignal.com5 in-lbs minimum to hold the trip rod in place and properly seal the enclosure. NOTE: If trip rod length is excessive, loosen the locking screw and remove the trip rod from the trip lever. Using pliers, break off the one (1) inch long notched section (see Fig. 10). Reinstall trip rod and repeat Step 3 procedure. 4.
Features
www.pottersignal.comValves, Dry Pipe Valves, Pre-Action Valves, or Deluge Valves. The pressure switch shall be actuated when the alarm line pressure reaches 4 - 8 psi (0,27 - 0,55 bar). Pressure type waterflow switches shall have a maximum service pressure rating of …
PFC-4064 Conventional Fire Alarm Panel
www.pottersignal.comThe PFC-4064 Conventional Fire Panel is a compact, expandable panel designed to monitor all facets of a fire alarm system and communicate the status to a monitoring station. The PFC-4064 panel is a listed and approved microprocessor based conventional fire panel and complies with UL-864, NFPA-70, and NFPA-72.
PFC-4410RC Installation, Operation, and Instruction Manual
www.pottersignal.comThis manual is designed to help with the specification, installation, and programming of the PFC-4410RC Release Panel. ... the design and layout of fire alarm and/or suppression systems for special hazard locations. The system shall be designed ... The PFC-4410RC complies with UL Standard 864, ULC S527, Canadian Electrical Code Part 1 C22.1 ...
SELECTABLE CANDELA CEILING MOUNT
www.pottersignal.comThe Potter CS/CHS Series is a ceiling mount strobe or horn/strobe combination that offers dependable audible and visual alarms and the lowest current consumption. The CS/CHS offers tamperproof field selectable candela options of 15, 30, 75, 95, 115 and 150 candela. The CHS horn offers a continuous or synchable temporal three in
Features
www.pottersignal.com1000E has space to allow the installation of up to six PAD100-SLCE SLC loop expansion cards. The cards mount on a stacker bracket that allows access to all SLC circuit connections. Technical Specifications Features • 1,270 addresses available on this analog addressable system • Additional system capacity achieved via multi-point SLC modules
Related documents
Design Guidelines-Fire Suppression System, Hydrants
www.safety.fsu.eduDesign Guidelines-Fire Suppression Systems, Hydrants . GENERAL: ... All Sprinkler system components shall be UL or FM listed in accordance with NFPA Sprinkler requirements. o. ... • The rated water working pressure for all hydrants shall be 200 psi and tested to 400psi by an
Data/ FM-200 Specification Sheet - PYRO-CHEM
www.pyrochem.comThe FM-200 Fire Suppression System is an engineered system utilizing a fixed nozzle agent distribution network.The system is designed and installed in accordance with the National Fire Protection Association (NFPA) Standard 2001, “Clean Agent Fire Extinguishing Systems.” When properly designed, the FM-200 system